Parallel output connection
Source: InternetPublisher:黄土马家 Keywords: Operational Amplifier Updated: 2021/11/08
The output power can be increased by using the parallel connection method. As shown in Figure ll-2a, two
LM 12 adopt follower connection method, and the output terminals are connected with equal resistors R. and R. After being connected in parallel
together, the voltage gain is accomplished using an LM 144 high voltage operational amplifier . The connection rule in Figure ll-2b
eliminates the need for an operational amplifier .
Latest Control Circuits Circuits
- Starting method of asynchronous motor with external frequency-sensitive resistor
- Design and principle analysis of practical electric curtain remote control device
- Light-controlled circuit design and analysis
- Design and analysis of a four-bit remote control component capable of remote reset
- Motorcycle anti-theft device circuit design
- Precious home appliance anti-theft alarm
- Control two contactors with one wire
- A novel resonance demonstration device
- Solar Flash Light
- NE556 Police siren sound generator
Popular Circuits
- Differential amplifier emitter negative feedback gain control circuit
- Pyroelectric automatic door control circuit
- Stapler control circuit
- DC voltage stabilizing circuit and zero-crossing detection circuit in the indoor unit control circuit of Hisense KFR-25GW-06BP inverter air conditioner
- Photoelectric output control circuit
- Relay control circuit a
- Sprinkler control circuit using AC motor
- Temperature detection control circuit of electric kettle
- Forward and reverse control circuit of micro DC motor b
- Wide input range non-synchronous voltage mode control circuit
京公网安备 11010802033920号