Composite Class A Amplifier
Source: InternetPublisher:ghaytweyhtoo Keywords: amplifier coupling Updated: 2020/03/27
It is a pure Class B output CL type power amplifier circuit. The front-end input part of this circuit does not use
the traditional differential input circuit, but uses a composite analog A analog rescue circuit with a single-ended input and a single-ended output. Its
working principle is shown in Figure 2-39. It is a directly coupled two-stage amplifier circuit, and its amplification capability is even greater than the two-stage
differential amplifier circuit. In the circuit, REI.Rl is the emitter resistor , which can be used as a DC negative feedback resistor to stabilize its working
point, and as an AC negative feedback resistor to increase the input impedance of the circuit. To match the preamp. The resistor RE is used to
achieve current sharing between the two tubes VTi.VT2.
- Simple and practical small amplifier
- Single-ended Class A amplifier using gallstone composite tube design
- Sugon New Tube 2A3C Single-ended Tube Amplifier
- Electronic toy dog
- Design of a tube amplifier that uses the mains electricity to directly provide screen working power
- A simple and practical tube amplifier
- LM4903/4905 high gain audio amplifier circuit
- High gain audio amplifier circuit composed of LM4818
- Dual power supply audio power amplifier circuit composed of LM4730/LM4731
- American Grado RA1 headphone amplifier
- Precision current detection amplifier design based on lithium battery detection
- How to use "virtual short" and "virtual break" to analyze op amp circuits
- Making a 6N7P Class B power amplifier circuit
- simple audio mixer
- Two-channel audio power amplifier circuit diagram analysis
- Sense amplifier circuit
- High-precision low-noise filter circuit design
- Differential bridge amplifier circuit diagram
- KBC-Ⅱ type programmable power circuit
- Parallel power op amp