Low resistance connection tester circuit diagram sharing
Source: InternetPublisher:elleny Keywords: tester low resistance Updated: 2024/01/04
The low resistance connection tester here can be used as a cable or wire tester, solder joints and other types of connections with resistance values between 0.25 and 4 ohms.
Circuit notes:
This simple circuit uses a 741 op amp in differential mode as a continuity tester.
The voltage difference between the non-inverting and inverting inputs is amplified by the op amp's full open-loop gain. Ignore the 470k and 10k controls for now and look at the op amp input. If the resistors are perfectly matched, the voltage difference is zero and the output is zero. However, using the 470k and 10k controls allows a small potential difference to be applied to the op amp inputs and disrupts the balance of the circuit. This is amplified, causing the op amp output to swing to full supply voltage and light up the LED.
Circuit Setup and Testing
The probe should first be connected to a resistor with a resistance between 0.22 ohms and 4 ohms. Adjust the control until the LED just lights up and there is resistance across the probe. The resistor should then be removed and the probes shorted and the LED should go out. Since low resistance values are extremely low, it is very important to keep the probe (whether it is an alligator clip, needle, etc.) clean, otherwise dirt will increase the contact resistance and cause the circuit to malfunction. The circuit should also be used with MOSFET type op amps such as the CA3130, CA3140 and JFET type such as the LF351. If the LED won't go off, you should connect the 10k preset to the offset zero terminal, pins 1 and 5, and the controller's tap to the negative battery terminal.
- How to measure short circuit and ground with a multimeter
- System display circuit of electric bicycle speed and odometer composed of CD4076 and 74LS138
- Simple electric tachometer
- TC02 temperature measurement circuit
- Circuit Fault Tracker
- How to Simplify Analog Front-End Design for Heart Rate Monitors
- Design of blood analyzer
- Using a Remote Control to Make a Crystal Oscillator Frequency Tester
- Digitally controlled operational amplifier gain circuit
- Differential amplifier circuit
- Three-phase alternating current detection circuit
- Bus door status detection circuit
- Using window discriminator as intensity detection circuit
- Detect the major point waveforms of the circuit
- Positive peak detection circuit
- Light detection circuit with output filter to reduce noise
- Differential light detection circuit
- HW200 telephone tester detection circuit
- Photoelectric pulse detection flying object injection speed detection circuit
- Infrared remote control detection circuit