Home >
Control Circuits >Motor Control > Change the motor from delta connection to single phase connection
Change the motor from delta connection to single phase connection
Source: InternetPublisher:念慈菴 Keywords: Wiring motor BSP switch Updated: 2021/11/13
(2) The motor with delta connection is changed to single-phase
wiring as shown in Figure 3-18. When starting, repeatedly open and close the switch SA. When the motor reaches the rated speed, turn off the switch
SA, and the motor can run with load. With this method, the starting torque of the motor is smaller.
Latest Control Circuits Circuits
- Replace the GE LOGIQ a200 ultrasound measurement key with a self-made touch switch
- Manual automatic air compressor control circuit
- Simple phase failure protection circuit composed of intermediate relay
- Design and analysis of the principle of automatic power-off switch during power outage
- Design and production of wireless multi-location control switch circuit
- Design and analysis of a four-bit remote control component capable of remote reset
- Motorcycle anti-theft device circuit design
- Infrared detection alarm
- Guest room power automatic controller
- New type of wind and rainproof automatic window that is simple and easy to make
Popular Circuits
- Homemade disinfectant circuit
- Electronic anti-asthma circuit
- Egg warming circuit
- Chicken supplementary light to increase egg production rate circuit
- Particle clogging alarm circuit of wheat seeder
- DC ammeter
- Amplitude modulation circuit composed of MC1496
- Multi-frequency resonant high-frequency power amplifier circuit for transmitter stage
- Small current generator circuit
- Sawtooth wave generator circuit (2)
京公网安备 11010802033920号