3021 views|1 replies

6

Posts

0

Resources
The OP
 

Program disappears after Flash power off [Copy link]

 Hi everyone, I just debugged a new FPGA board, and the output test images were normal, but I encountered a problem when it came to solidification. I used NIOS to solidify the elf+sof files into EPCS. After the burning was complete, I turned off the power and restarted, and the program ran normally, and the current and other things were normal. I thought the solidification was normal, so I turned off the power and left it there, but after a while, the program did not run when I restarted it! The current did not change either! Finally, I tested it and after the burning was completed, I turned off the power and restarted it after about a minute, and the program was gone. I would like to ask the masters what kind of problem is this? Is it the instability of the hardware or the problem with the software? ? ? Thanks
This post is from Altera SoC

Latest reply

Check the programming voltage.  Details Published on 2018-10-8 23:55
 
 

47

Posts

0

Resources
2
 
Check the programming voltage.
This post is from Altera SoC
 
 
 

Guess Your Favourite
Find a datasheet?

EEWorld Datasheet Technical Support

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号
快速回复 返回顶部 Return list