After allegro finishes drawing the PCB, I want to change the drawing size

shijizai

After allegro finishes drawing the PCB, I want to change the drawing size [Copy link]

After drawing the PCB with Allegro, I want to change the drawing size. After changing it in the design parameter editor, the drawing does not feel smaller, but the components and frames on the drawing disappear. How should I change the drawing size at this time?

xxxlzjxxx

Did you change the background size?

shijizai

xxxlzjxxx posted on 2018-8-16 11:04 Did you change the background size?

Yes, it is here. I also found the setting here, but I don’t know what I did before. As soon as I changed the parameters in this interface, the components disappeared and the size did not change.

xxxlzjxxx

Shijizai posted on 2018-8-16 16:20 It is here. I also found the setting here, but I don’t know what I did before. As soon as I changed the parameters in this interface, the components disappeared. ...

Haha. Is the software not cracked well? I have used all versions of Cadence and have never encountered this problem.

shijizai

xxxlzjxxx posted on 2018-8-17 09:06 Haha. Is the software not cracked properly? I have used all versions of Cadence and have never encountered this problem

But the unfinished version I saved before can be resized normally, but this finished one can't Is there something I set wrong?

xxxlzjxxx

Shijizai posted on 2018-8-17 10:13 But the unfinished version I saved before can be resized normally, but this finished one can't. Is there something wrong with my settings?

Emmmmm, it's hard to find the reason