【 Domestic FPGA Anlu High Integration Low Power Consumption SF1 Series FPSoC】 Part 7 RISC-V IP and MCU Programming

常见泽1

【 Domestic FPGA Anlu High Integration Low Power Consumption SF1 Series FPSoC】 Part 7 RISC-V IP and MCU Programming [Copy link]

 

Finally found that it still needs to be programmed at the upper level

It is better to use the official routine directly

Open the MCU software

Simple IO programming

Then compile and generate an executable file

Simultaneous downloads always have problems

After searching, I finally found

You need to import Bit and HEX first.

Then modify the Mode

It has to be changed to Hex

Then click Bit

If you don't click Bit, an error will be reported

Click RUN again

lugl4313820

I put a lot of thought into writing this post, thank you for your hard work!