New Definition TBK-RD8T3x Development Board - New Definition TK Debugging Primer

蓝雨夜

New Definition TBK-RD8T3x Development Board - New Definition TK Debugging Primer [Copy link]

 

New Definition TBK-RD8T3x Development Board - New Definition TK Debugging Primer

1. New EasyCodeCube Project

2. Select the model

Click here to start the project

3. Select the touch type

4. Configuration and TK debugging

5. Hardware Connection

The debugging system has been connected to TBK-RD8T3XV1.0 via RD LINK PRO

Select: Touch panel connected, enter on-board tuning

6. Select the target model

Configure touch pins

Click: Channel Configuration

7. Target Touch Button

The six touch buttons on the target board correspond to: TK22, TK23, TK24, TK25, TK26, TK27

Click the pin directly, green will activate the touch function

8. Single channel debugging

Click OK to start touch debugging for a single channel

9. Debugging TK22 Channel

Click 1 Green, TK22 channel,

Click 2 to start debugging

Complete the debugging steps according to the status and information prompts in 3.

10. Read untouched parameters

11. Read touch parameters

12. Current channel debugging completed

13. Graphic display touch effect

Click on the chart to display

The peak represents the touch state

14. Complete export parameter configuration

15. Resources

For detailed parameters, please refer to https://rdsmcu.com/RDSfiles/New Definition Magic Box Touch Quick Application Manual.pdf

Capacitive touch can use this tool to easily and intuitively adjust the sensitivity of different touch structures, intermediary materials, and distances to capacitance, as well as set parameter thresholds!

damiaa

EasyCodeCube is a good name, a bit like STM32CUBEMX

火辣西米秀

This newly defined Magic Box Touch Quick Application Manual seems to need to be studied carefully

WWW266QQQ

Interrupt GPIO8 (C code).rar (385.5 KB, downloads: 0)

2023-11-2 18:40 上传

点击文件名下载附件

Hello, I read your post and you are an expert on 28027. I would like to ask you, I use PSIM to generate 28027 software, and then generate HEX or COF, but it does not run successfully. Can you help me look at the code? Thank you.

WWW266QQQ

It just so happens that I am also studying power supply, and I have simulation data. I hope we can learn together, thank you.