JLC board frame layer problem

1nnocent

JLC board frame layer problem [Copy link]

The JLC board frame layer has been hollowed out, and the hollowed out part is still there in the 3D view (only a black circle). I remember that the 3D view will directly remove the hollowed out part after hollowing out the PCB. I want to dig a 5mm diameter hole in the four corners and a large hole in the middle of this PCB. Is this possible? The proofing view is a little different from before, please confirm.

秦天qintian0303

I wanted to pick it up, but gave up. When I imported it into PCB, it prompted that the pins and packages did not match. No matter how I counted, they were correct. It was difficult to draw without their components. I might as well pay for proofing.

1nnocent

Qintianqintian0303 posted on 2023-1-20 11:35 I wanted to pick it up, but gave up. When I imported it into PCB, it prompted that the pins and packages did not match. No matter how I counted, they were correct. It was difficult to draw without their devices. There were...

I was really uncomfortable at first, but now I am getting used to it.

。

qwqwqw2088

For this type of board shape, it is best to draw it in CAD and import it.