[2022 Digi-Key Innovation Design Competition] 4. Run a simple interface directly

ddllxxrr

[2022 Digi-Key Innovation Design Competition] 4. Run a simple interface directly [Copy link]

 

I'm having some trouble with TouchGFX lately.

There are the following points:

1. TouchGFX is not a stand-alone application, it needs to be used together with CubeMX, CubeIDE (optional), and even CubeProgrammer.

2. The TouchGFX file generated from CubeMx cannot be updated, that is, the code cannot be found.

3. The code I worked so hard to produce always fails to compile or has problems with missing files. In short, it's not fun.

Let’s just draw a simple stroke on TouchGFX first!

I select my development board directly from TouchGFX

Then cover the entire screen with BOX, and select a button with text and a circle.

Click on the internal behavior on the right

It's also very simple, just click a button to hide the circle.

There is a little trouble when downloading, the system prompts you to install STM32CubeProgrammer.

I think this is a bit overbearing, as STLINK was enough before.

I had no choice but to install STM32CubeProgrammer

Here is the running effect:

After clicking, the blue circle disappears.

lugl4313820

The interface appears, which means 80% success.

秦天qintian0303

The OP is very quick. I suggest you share some tips on touchGFX.

ddllxxrr

lugl4313820 posted on 2022-7-30 18:22 The interface is out, 80% successful.

It's too early! Now the program and the interface cannot connect

ddllxxrr

Qintianqintian0303 posted on 2022-7-30 19:41 The OP is very fast. I suggest you share some tips of touchGFX

Someone will reply

吾妻思萌

Awesome!