How to remove the red cross on the schematic diagram

huo_hu · Published on 2018-11-13 15:30

How to remove the red cross on the schematic diagram [Copy link]

This post was last edited by huo_hu on 2018-11-13 15:31 It is ERC. I think it is related to the setting of the deletion grid. I changed the deletion grid unit from imperial to metric before. Is it related to this?

The cross is red in AD. It is a problem with the screenshot. Thanks AD13.1 version

okhxyyo · Published on 2018-11-13 16:03

I haven't touched sweat for a long time. I remember there is such a function, but I can't remember what it is used for. It is not often used. . ╯□╰. I will give it to the teacher.

okhxyyo · Published on 2018-11-13 16:43

I remember there is a function that places a symbol to indicate that the rule check will not be performed at this position. It seems to be an x? Is this the function?

bigbat · Published on 2018-11-13 17:49

The problem is mainly with the pin connection settings of your components. The system kindly reminds you that "your pins are not connected or the connection types do not match!"

qwqwqw2088 · Published on 2018-11-13 20:09

Go to the component library to check the pin type. If you are not sure if this is the cause, try changing the component pin from output to passive to see if it solves the problem.

ddllxxrr · Published on 2018-11-14 08:53

DELE can delete

曹伟1993 · Published on 2018-11-14 08:57

This is probably because of the pin settings. In the package, you set this pin as input/output, but when using it, this pin is left floating, and an error will be reported.

hongying · Published on 2018-11-14 10:19

Can be deleted directly.

huo_hu · Published on 2018-11-14 13:34

bigbat posted on 2018-11-13 17:49 It is mainly due to the pin connection settings of your components. The system kindly reminds you that "your pins are not connected or the connection types do not match!"

The pins are the same. I have checked and it is not what you said.

huo_hu · Published on 2018-11-14 13:35

ddllxxrr posted on 2018-11-14 08:53 You can delete it with DELE

You can't delete it, it's added automatically by the system after compilation

huo_hu · Published on 2018-11-14 13:38

I suspect that the problem is that the schematic library uses imperial units while the schematic diagram uses metric units. The cross tells me that the connection is not connected after the compilation. I changed the schematic library again and it is fine now. Thank you everyone

How to remove the red cross on the schematic diagram [Copy link]

Latest reply

Comments

Comments