Please help me, I got this error when I was drawing the board.

西里古1992

Please help me, I got this error when I was drawing the board. [Copy link]

It works fine after I ticked the Allow short circuit option. Why?

sjl2001

There is no rule for your wiring. There are both horizontal and vertical lines on the front and back.   

chenzhufly

Without defining the rules, I think it is wrong to cross-check, and it is easy to make mistakes.

1352937429

There is something wrong with your wiring! It seems that your ground wire is not connected to the original part.

qwqwqw2088

The default state of this rule is not checked. It is used to set whether short circuits are allowed between different networks. Checking it means that the wires set above can be short-circuited, but it depends on whether all networks, networks, network classes and other conditions are selected. If there is no special need, it is generally not used.

曹伟1993

What you ticked refers to the same layer, and different networks can cross, but this is wrong. Generally, you can't tick it. The error reported in your graph should refer to the distance between different networks being too close.

devilyy

By looking at your drawings, these errors are related to the design rules, size settings, aperture size settings, and silk screen spacing settings. They may all be related.

btty038

rule