stm32 F7 League of Legends Design Competition project introduction
Reflective blood oxygen heart rate signal acquisition and monitoring recording system
Smart camera based on visual tracking and remote monitoring
Virtual remote firefighting robot
Independent balancing robot
Multifunctional measuring instrument
Internet radio
Emergency call system for the elderly
Now I have a four-in-one digital tube. When designing the schematic diagram, it was divided into four separate digital tubes. What should I do when adding a package to it?
I have a question: 1. How to get the drawing surface from the panel in WinCE5 C#? Note: The simplified version of the compect Frame Work does not support CreateGraphics. I used Graphics.FromHdc() but
Abstract: This paper introduces the system structure and overall design of the switching voltage regulator based on MSP430 single-chip microcomputer. The hardware circuit of this design consists of a
This is the schematic diagram for JTAG, completely copied from TI...
This is my crystal oscillator. I didn't know it at the time... I also put the crystal oscillator on the opposite side, and the SPI
I have worked in technical development for many years. I started as a small engineer who soldered circuit boards and gradually became a project manager, R&D manager, and now a chief engineer. As an en