[size=4]1. Introduction to IAP [/size] [size=4]IAP is the abbreviation of "in applicatin programming", which means that the MCU can obtain new code in the system and reprogram itself, that is, change ...
As the title says, in a boost circuit, the input voltage fluctuates between 12-18V, the output voltage is 24V, the output current is 2A, and the switching frequency is 50kHz. How should the RC buffer ...
Hello Expert,
I looked at the schematic of the DC2222A (LTC2500 evaluation board) and found that all digital signal transmission lines (such as between the FPGA and the ADC) have a 33Ω series resistor...
[i=s]This post was last edited by Baboerben on 2020-9-12 21:19[/i]For functions that require always-on, such as voice control or the device needs to obtain and process sensor data in real time, DSP is...
Source: csdnDavis Bell, CEO of software company Canopy, recently posted a short article on his LinkedIn, claiming that his company had just fired two employees who worked multiple full-time jobs. Howe...
As shown in the figure, the test voltage is marked on the figureThe voltage on the left side of 330K becomes lower when it reaches the op amp's non-inverting input, but the voltage at the feedback-reg...