::
4.3” Disp la y
::
QuickStart Guide
www.logicpd.com
ZOOM 4.3” Display
QuickStart Guide
We fast forward
the evolution of
new products.
1 Introduction
Congratulations on your purchase of the Zoom™ 4.3” Display
Kit. The 4.3” LCD connects directly to Logic’s Zoom SDK and LV
baseboards allowing you to immediately begin development work.
1.1 Zoom 4.3” Display Kit Features
+ 4.3” WQVGA TFT LCD with touch screen
+ 60-pin LCD connector to interface with baseboard
1.2 Register your Display Kit
Registration provides you access to the latest revision of this
manual, as well as other documentation and resources. In addition
to downloads access, registration provides future notifications when
Logic releases documentation and updates for your product.
To register, visit the Logic Support website at
http://www.logicpd.com/product-support and click on “Register Your
Kit”. Follow the on-screen instructions to register your product.
2 Connect LCD to Baseboard
1.
Locate the 60-pin LCD connector on your baseboard (reference
designator J11).
2.
3.
Align the keyed connector on the LCD board with the baseboard
60-pin LCD connector.
Press straight down on the LCD board until the baseboard
connector levers move into a vertical position.
Note:
Use caution
when pressing down on the LCD board as the solder points may
be sharp.
4.
5.
Before using the LCD touch screen, remove the protective
plastic film covering the display.
To remove the LCD board from the baseboard, pull back on the
ejector levers until the connector on the display board moves up
and disengages from the baseboard 60-pin LCD connector.
2.1 Baseboard Jumper Settings
If you are attaching the display to an LV baseboard (as pictured in
step 3), verify that jumper JP1 is placed across pins 2 and 3.
1
JP1
3
If you are attaching the display to an SDK baseboard, verify that
jumpers J6 are placed on pins 5 and 6.
+
2
J6
–
6
6
5
+
2
J6
–
6
1
5
1
5
Normal Operation
JTAG Operation
京公网安备 11010802033920号
EEWORLD
