EEWORLDEEWORLDEEWORLD

Part Number

Search

PH1-NLASC2805

Description
Transponder, SC/UPC Connector,
CategoryWireless rf/communication    Optical fiber   
File Size240KB,6 Pages
ManufacturerJDS Uniphase Corporation ( VIAVI )
Websitehttp://www.jdsu.com/index.html
Download Datasheet Parametric View All

PH1-NLASC2805 Overview

Transponder, SC/UPC Connector,

PH1-NLASC2805 Parametric

Parameter NameAttribute value
Objectid1871067407
Reach Compliance Codeunknown
Other featuresIT ALSO OPERATE FROM 1280NM TO 1600NM
body height13.2 mm
Body length or diameter84.1 mm
Communication standardsOC-192, SONET
Connection TypeSC/UPC CONNECTOR
Emitter/Detector TypeAVALANCHE PHOTODIODE
Fiber optic equipment typesTRANSCEIVER, TRANSPONDER
Nominal operating wavelength1533 nm
Nominal optical power output1.584 mW
minimum return loss-27 dB
Sensitivity-24 dBm
COMMUNICATIONS MODULES & SUBSYSTEMS
10 Gb/s TDM/DWDM 300 Pin SFF MSA SR2/IR2/LR2 Transponder
PH1 Series
Key Features
• Three configurations supporting SR2/IR2/LR2 applications
• Supports dense wavelength division multiplexing
(DWDM) applications (without wavelocker)
• Microprocessor controls to support I2C
• Integrated 16:1/1:16 mux/demux
• Small form factor package (2.2" x 3.0" x 0.53") for high
density applications
• Low power consumption: 4.8 W typical, 6.8 W maximum
for TDM applications
• 70 °C maximum operating temperature
• High sensitivity PIN or APD receivers
• SONET, FEC, Ethernet and Multirate Capable Versions
• Forward, counter and line timing clocking modes
Applications
Telecommunications
Metropolitan Area Networks
Subscriber loop
Intra-office SONET/SDH
High bit-rate data communications
JDSU 10 Gb/s PH1 Series transponders are intended for 1550 nm system
applications with reaches of up to 80 km. The series includes three different
transponders for SR2 (25 km), IR2 (40 km), and LR2 (80 km) TDM or DWDM
applications. Each transponder accepts 16 bits of parallel digital data and converts
it to a 10 Gb/s NRZ modulated optical signal. It also accepts a 10 Gb/s NRZ
modulated optical signal and converts it into 16 bit wide parallel digital data.
The PH1 series offers low DC power dissipation and is available in either a small
form factor package (2.2 x 3 x 0.53 inches) or in a larger footprint (3.5 x 4.5 x 0.53
inches) package, depending on system thermal performance requirements. The
transmit design uses an Electro-Absorptive Modulated Laser (EML) which,
depending on the configuration, produces an average output power of between
-4 dBm to 2 dBm (EOL). A PIN (-17 dBm typical sensitivity) or APD (-24 dBm
typical sensitivity) receiver is available, based on system configurations.
JDSU PH1 Series transponders are designed to support the following data rates:
9.953 Gb/s (SONET), 10.3125 Gb/s (Ethernet), 10.664 Gb/s (FEC Encoded),
10.709 Gb/s FEC, or 11.09 Gb/s EFEC. They meet all applicable SONET/SDH standards.
Compliance
• Telcordia GR-253-Core
NORTH AMERICA
:
800 498-JDSU (5378)
WORLDWIDE
:
+800 5378-JDSU
WEBSITE
:
www.jdsu.com
Where is the SD card of sensorTile.box
First time posting. The reason for this was the information sent to the mailbox. I browsed through several posts and found that there was an SD card, but I couldn't find a microSD card in the pictures...
jackeyjiang ST MEMS Sensor Creative Design Competition
Some questions about Bluetooth Mesh
Recently, due to work needs, I started to get in touch with Bluetooth Mesh. I looked it up and found that Bluetooth Mesh was not long ago, probably in 2017, so it has been 4 years now. Although I am n...
w494143467 RF/Wirelessly
Read the good book "Operational Amplifier Parameter Analysis and LTspice Application Simulation" for free, take notes, and master the knowledge of operational amplifiers thoroughly
April Reading Festival, good books will enlighten the world~hello, everyone~I am here to urge progress and encourage everyone to read good books. I recommend good books to you all, okhxyyo~Come and re...
okhxyyo Analog electronics
About the problem of inaccurate reading of MAX6675
I need help from all the experts: When I use the max6675 chip to read the thermocouple, I accidentally find that the temperature of the thermocouple is 20477 or 0. What is the reason? Has anyone encou...
张合伦 stm32/stm8
Push-pull circuit
Why is the lower arm PNP transistor of the H-bridge push-pull circuit often damaged, and the three legs of the transistor are directly short-circuited?...
cxq742536574 Analog electronics
How can a hybrid hardware engineer who doesn't know embedded programming prove that he has mastered common communication interfaces?
As the title says, everyone is welcome to chat. For example, for commonly used interfaces such as RS485, IIC, SPI, CAN, etc., do you know the common circuit structure and electrical level range, such ...
呜呼哀哉 Analog electronics

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号