I just started learning Verilog HDL programming in college. The course design is to make a simple digital clock, but when downloading the code to the board, it fails. What is the reason for this? Than...
The load is an ozone generator 3.7V, the working current is 400ma, and the battery power supply is 3.7V 2500MAH controlled by the Pmos switch . During use, it is found that after the ozone module work...
1. Introduction With the continuous development of communication technology, computer network system communication is an important direction of current technological development. However, using the ...
[i=s]This post was last edited by damiaa on 2021-3-16 14:42[/i]Silk screen is AA6B
SOT23-6 package
With 2.2UH inductor
3.7~4.2V boost to 5V
With picturesAsk for model number!!!...
A:
I would like to ask, I want to add uart6 driver to CB140, how do I determine the address of this pin?
I want to add uart6 now
As shown
B:
arch/arm/boot/dts/myimx6ek140p-8uart.dtsi
Dual Ethernet and...
I just saw an article from Avnet on the Internet, and I also want to know the answer to the question.The speed of charging is a "complaint". For example, it takes about 36 minutes to fully charge an e...