Moisture Sensitivity Level (MSL) – This product is Hermetically Sealed and
not Moisture Sensitive - MSL = N/A: Not Applicable
FEATURES:
• Suitable for RoHS compliant reflow
• Low height reduced to 3.3mm
• Available suitable for thin equipment
• Tight stability & extended temperature
Reduced height
to 3.3mm
Pb
RoHS
Compliant
11.4 x 4.7 x 3.3 mm
APPLICATIONS:
• Computers, Modems, Microprocessors
• Wireless Applications
STANDARD SPECIFICATIONS:
PARAMETERS
Parameters
Minimum
3.579545
Typical
-----
-----
-----
Maximum
24.00
50.00
70.00
Units
Notes
Fundamental AT
(Standard)
Fundamental AT or BT
(See options)
3
rd
Overtone
(Standard)
)
Frequency Range
24.01
24.01
MHz
Operation Mode
Operating Temperature
Storage Temperature
Frequency Tolerance @+25°C
Frequency Stability over the Operating
Temperature ( ref. to +25°C)
Equivalent series resistance (R1)
Shunt capacitance (C0)
Load capacitance (CL)
Drive Level
Aging
Insulation Resistance
Drive level dependency (DLD)
Fundamental or 3
rd
Overtone
0
-----
+70
-55
-----
+125
-50
-----
+50
-50
-----
-----
-----
-5
-----
See table 1 below
-----
18
100
-----
+50
7
-----
1000
+5
ºC
ºC
ppm
ppm
Ω
pF
pF
µW
ppm
See options
See options
See options
(For BT cut, ±100ppm max.at
-10° C to +60° C only)
Standard
(See options if
other than STD)
500
-----
-----
MΩ
Minimum 7 points tested: from 1µW to 500µW.
Change in frequency (Maximum - Minimum) over DLD range < ±10ppm
Change in ESR (Maximum - Minimum) over DLD range < 25% of Max ESR
value.
Maximum ESR over DLD range < Max ESR value.
ESR (Ω)
180
120
100
80
60
50
40
100
80
REVISED: 11.15.2016
5101 Hidden Creek Lane Spicewood TX 78669
Phone: 512-371-6159 | Fax: 512-351-8858
For terms and conditions of sale please visit:
www.abracon.com
ABRACON IS
ISO9001-2008
CERTIFIED
@25°C±3°C
First year
@ 100Vdc ± 15V
TABLE 1: ESR
FREQUENCY (MHz)
3.579545 - 4.999 (Fund.)
5.000 - 5.999 (Fund.)
6.000 - 7.999 (Fund.)
8.000 - 8.999 (Fund.)
9.000 - 9.999 (Fund.)
10.000 - 15.999 (Fund.)
16.000 - 50.000 (Fund.)
24.01 - 31.999 (3rd O/T)
32.000 - 70.00 (3rd O/T)
LL C
HC/ 49US (AT49) LOW PROFILE SURFACE
MOUNT MICROPROCESSOR CRYSTAL
ABLS2
Pb
RoHS
Compliant
Options and Part Identification
(left blank if standard)
Reduced height
to 3.3mm
11.4 x 4.7 x 3.3 mm
| | | | | | | | | | | | | | |
ABLS2 -
Frequency in MHz
Please specify the frequency
in MHz. e.g. 14.31818MHz
MHz -
-
-
-
-
Packaging
Blank: Bulk
T: Tape&Reel
Oscillation Mode
F: Fund. AT>24MHz
FB: Fund. BT>24MHz
Load Capacitance (pF)
Please specify CL
(Minimum 10pF) in pF or
S for series
Custom ESR if other
than standard
R□
□:
Specify a value in
Ω
(e.g.: R40)
Operating Temp.
A: -10°C ~ +60°C
B: -20°C ~ +70°C
C: -30°C ~ +70°C
N: -30°C ~ +85°C
D: -40°C ~ +85°C
J*: -40°C ~ +105°C
K*: -40°C ~ +125°C
L*: -55°C ~ +125°C
Freq. Tolerance
H5: ± 5 ppm
1: ± 10 ppm
7: ± 15 ppm
2: ± 20 ppm
3: ± 25 ppm
4: ± 30 ppm
Freq. Stability
U**: ± 10 ppm
G: ± 15 ppm
X: ± 20 ppm
W: ± 25 ppm
Y: ± 30 ppm
H: ± 35 ppm
Q: ± 100 ppm
R: ± 150 ppm
NOTE: Fundamental BT frequency stability ± 100ppm max. at -10° C to +60° C only.
* Frequency stability ±50ppm, ±100ppm, ±150ppm only. Contact ABRACON for tighter frequency stability.
** Contact ABRACON for availability of ±10ppm with other Operating Temperature options.
LL C
5101 Hidden Creek Lane Spicewood TX 78669
Phone: 512-371-6159 | Fax: 512-351-8858
For terms and conditions of sale please visit:
www.abracon.com
REVISED: 11.15.2016
ABRACON IS
ISO9001-2008
CERTIFIED
HC/ 49US (AT49) LOW PROFILE SURFACE
MOUNT MICROPROCESSOR CRYSTAL
ABLS2
Pb
RoHS
Compliant
OUTLINE DRAWING:
Reduced height
to 3.3mm
11.4 x 4.7 x 3.3 mm
| | | | | | | | | | | | | | |
TAPE & REEL:
T = tape and reel (1000pcs/reel)
Reflow Profile
Zone
1
2
3
Description
Preheat
Temperature
T
SMIN
~ T
SMAX
150°C ~ 180°C
T
L
230°C
Time
60 ~ 120 sec.
30 ~ 40 sec.
10 sec. MAX
Peak Heat
T
P
260°C
Dimensions: mm
ATTENTION:
Abracon products are COTS - Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated, Automotive Applications.
Abracon’s products are not specifically designed for Military, Aviation, Aerospace, Life-dependant Medical applications or any application requiring high reliability where component
failure could result in loss of life and/or property. For applications requiring high reliability and/or presenting an extreme operating environment, written consent and authorization
from Abracon is required. Please contact Abracon for more information.
I bought an mv3 during a promotion some time ago, and I've been playing with it for a while. While playing with the mv3, I accidentally clicked the upgradebutton, and the firmware crashed, and the mv3...
It is very uncomfortable to wear a mask when going out in summer when the temperature is over 30 degrees. The mask will be soaked with sweat after walking in the sun for 5 minutes.Is there any good wa...
I am working on the custom method (using the serial port) to program the FLASH of 430. After the program is completed, the power is turned off and reset, and the reset button can run the new program. ...
Multiple sources told Nikkei Asian Review that since last year, two chip projects supported by mainland China have hired a total of more than 100 experienced engineers and managers from TSMC. Sources...[Details]
Because it allows multiple I2C bus devices to be connected to the bus, the devices connected to the I2C bus are open-drain or open-collector, which can realize the wired AND function. At the same tim...[Details]
BEIJING, China – March 1, 2022 – Qorvo®, a leading provider of innovative RF solutions that connect the world, today announced that its popular “Design Summit” webinar series will return in March 202...[Details]
Hardware Differences APROM size is 16KB and 18KB The APROM start address is different ADC clock selectable and sampling time configurable IIC SCL pin hold time extension enable The pins of both a...[Details]
China Energy Storage Network:
Changes and re-signings of annual trading contracts in 2021
In October 2021, the National Development and Reform Commission issued the "Notice on...[Details]
Key to any good oscilloscope system is the ability to accurately reconstruct waveforms, a capability known as signal integrity. A Tektronix oscilloscope is similar to a camera; it captures an image o...[Details]
According to previous official news, Qualcomm will hold the Snapdragon Technology Summit on December 1, when the next year's mainstream flagship standard Snapdragon 875 new generation mobile p...[Details]
Some soft PLC startup modes are divided into cold start, warm start and hot start. There are some instructions in the official help document, but they are directly translated.
In fac...[Details]
While advances in automotive technology, including crash structures, airbags, brakes and tires, have helped improve vehicle safety, we are still exposed to a variety of road risks. Moreover, these ri...[Details]
Atmega16 uses progisp to download and reports flash verify error at :0h After a lot of hard work to find the cause, I finally found a solution, you can refer to it. First, make sure the ATmega16 mi...[Details]
China Energy Storage Network News:
As of the end of June, the total number of public charging piles has reached 81,780. Among them, there are 13,468 DC piles, 16,447 AC/DC integrated piles, a...[Details]
International Electronic Business News The automotive chip shortage seems to be showing signs of easing. Morgan Stanley Securities pointed out in the latest Asia-Pacific Automotive Semiconductor Repo...[Details]
In order to alleviate the energy problem, on the basis of being fully compatible with the existing power supply system, the system uses wind and solar energy to replenish electricity, and comes w...[Details]
The power grid is a physical network that every household needs to use. The basic function of existing power lines is to transmit electricity. Using existing power lines to achieve data communicati...[Details]
As environmental awareness gradually increases, countries around the world are competing to develop environmentally friendly cars. my country is also investing in the development of battery-powered...[Details]