3.2 x 2.5 mm Package Pinout ...................................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Dimensions and Patterns ― 3.2 x 2.5 mm................................................................................................................................. 15
Dimensions and Patterns ― 5.0 x 3.2 mm................................................................................................................................. 15
Dimensions and Patterns ― 7.0 x 5.0 mm................................................................................................................................. 16
Additional Information ................................................................................................................................................................ 17
Revision History ......................................................................................................................................................................... 18
Rev 1.00
Page 2 of 18
www.sitime.com
SiT3342
1 MHz to 220 MHz Ultra-low Jitter, Endura™ Series Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
1
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Acceleration (g) sensitivity,
Gamma Vector
Supply Voltage
F_g
–
Typ.
–
–
–
–
–
–
–
–
–
–
Max.
220
+15
+25
+35
+50
+70
+85
+95
+105
0.1
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
ppb/g
Extended Industrial
Low sensitivity grade; total gamma over 3 axes; 15 Hz to 2 kHz;
MIL-PRF-55310, computed per section 4.8.18.3.1
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variations, and first year aging at 25
°C,
with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Rugged Characteristics
Supply Voltage
Vdd
2.97
2.7
2.52
2.25
Pull Range
PR
3.3
3.0
2.8
2.5
3.63
3.3
3.08
2.75
V
V
V
V
ppm
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Contact SiTime
for other input bandwidth options
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150,
±200, ±400, ±800, ±1600,
±3200
90%
–
–
–
–
–
–
10
10
–
–
10%
–
–
1.0
–
Input Characteristics
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Startup Time
OE Enable/Disable Time
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
–
–
100
–
–
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value
f = 156.25 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
VC_U
VC_L
VC_z
V_c
Lin
–
Vdd
Vdd
MΩ
kHz
%
Positive Slope
Output Characteristics
Startup and OE Timing
Rev 1.00
Page 3 of 18
www.sitime.com
SiT3342
1 MHz to 220 MHz Ultra-low Jitter, Endura™ Series Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
Min.
–
–
–
–
Vdd-1.15
Vdd-2.0
1.2
–
–
–
Typ.
78
53
0.15
–
–
–
1.6
225
1.0
0.225
Max.
92
61
–
33
Vdd-0.7
Vdd-1.5
2.0
290
1.6
0.270
Unit
mA
mA
A
mA
V
V
V
ps
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3V or 2.5V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 100, 156.25 or 212.5 MHz, Vdd = 3.3V or 2.5V
f = 156.25 MHz, Integration bandwidth = 12 kHz to 20 MHz, all
Vdd levels, includes spurs, pull range =
±100
ppm. Temperature
ranges -20 to 70 °C and -40 to 85 °C
f = 156.25 MHz, Integration bandwidth = 12 kHz to 20 MHz, all
Vdd levels, includes spurs, pull range =
±100
ppm. Temperature
ranges -40 to 95 °C and -40 to 105 °C
f = 156.25 MHz, IEEE802.3-2005 10 GbE jitter mask integration
bandwidth = 1.875 MHz to 20 MHz, includes spurs, all Vdd
levels
f = 100, 156.25 or 212.5 MHz, Vdd = 3.3V or 2.5V
f = 156.25 MHz, Integration bandwidth = 12 kHz to 20 MHz, all
Vdd levels, includes spurs, pull range =
±100
ppm. Temperature
ranges -20 to 70 °C and -40 to 85 °C
f = 156.25 MHz, Integration bandwidth = 12 kHz to 20 MHz, all
Vdd levels, includes spurs, pull range =
±100
ppm. Temperature
ranges -40 to 95 °C and -40 to 105 °C
f = 156.25 MHz, IEEE802.3-2005 10 GbE jitter mask integration
bandwidth = 1.875 MHz to 20 MHz, includes spurs, all Vdd
[font=宋体][size=4]As shown in the figure, 6 networks are connected to GND_SIGNAL, but the GND_SIGNAL on this page of the PCB is connected together when the netlist is called, but it is not connected to...
In the latest update ( py: Implement partial PEP-498 (f-string) support. ), most of the PEP-498 specification f-strings are implemented.In the lexer, it is implemented as a grammatical transformation ...
(1) __delay_cycles() is a built-in delay function of IAR_msp430, which is used for accurate delay. You can write a program as follows:------------------------------------------------------------------...
The system device module includes two registers: status and control, which need to be configured. The DM6437 device has four different module states—Enable, Disable, SyncReset, or SwRstDisable
1. Boot...
[i=s]This post was last edited by jinglixixi on 2021-5-14 09:59[/i]If you want to do your work well, you must first sharpen your tools. If you want to develop CC2650, you can't do without building a d...
STM32 MCU application and full case practice
https://download.eeworld.com.cn/detail/sigma/623925Detailed explanation of microcontroller serial port communication and measurement and control applicatio...
We often see various trigger modes in the trigger options of oscilloscopes. After setting the trigger mode, the waveform still cannot be displayed stably. Is it because the oscilloscope cannot meet th...[Details]
Chongqing's first integrated source-grid-load-storage demonstration station integrating photovoltaic, energy storage, charging, discharging, battery replacement and battery testing has been completed....[Details]
Many programs for DS1302 and 1602 on the Internet have big problems. I wrote a complete and detailed one for everyone to understand. You can modify the port yourself.
#include reg51.h
#include int...[Details]
LM86 is an 11-bit remote semiconductor digital temperature sensor launched by National Semiconductor Corporation . It has a two-wire system management bus (SMBus) serial interface and can accurately ...[Details]
I have been DIYing a brushless motor driver recently. Since it is my first time, it takes a little time. I will share it in this public account after it is completed. This article summarizes the wo...[Details]
Recently, Shenghong Co., Ltd. reached a strategic cooperation with ChargeTronix, a leading electric vehicle charging solution provider in the United States. The two parties will work together to ex...[Details]
First of all, I was inspired by this blogger's article, which deepened my understanding of USART. The following is the program I modified and experimented with. Original text: http://www.cnblogs.co...[Details]
In addition to one electrode G still called the control electrode, the other two electrodes of the bidirectional thyristor are usually no longer called the anode and cathode, but are collectively cal...[Details]
Recently, the National Bureau of Statistics announced the operation of China's Purchasing Managers' Index in May 2023. The data showed that in May, the manufacturing Purchasing Managers' Index (PMI...[Details]
Unipolar Stepper Motor Controller Circuit--Unipolar Stepper Motor Controller
This is a very good integrated circuit. There is no need for any external glue logic to drive the circuit, there is...[Details]
There are roughly the following types of photography subjects involved in our travels: landscape, humanities, and portraits. Traveling is not for photography. No one wants to carry a lot of equipment...[Details]
The 2021 ZTE Government and Enterprise Cloud Network Ecosystem Summit was recently held at the Shangri-La Hotel in Nanjing. With the theme of "Building the Digital Economy and Win-Win Cloud Network E...[Details]
Ball pins are widely used in the connection, fixation and positioning of automobiles and other important equipment. Their reliability has a significant impact on the working reliability and safety of ...[Details]
In the AI era, from computational intelligence to perceptual intelligence, cognitive intelligence and future general artificial intelligence, the development of SAIC Volkswagen is highly time-mat...[Details]
PCB Design
京公网安备 11010802033920号
EEWORLD
