Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[b]1. What are bit segments and alias areas? [/b] Do you remember MCS51? MCS51 has bit operations, which are operations with one bit (BIT) as the data object. MCS51 can simply operate the second bit o...
[i=s]This post was last edited by xusiwei1236 on 2022-6-12 17:19[/i]This article will introduce how to use RT-Thread Studio to connect the HPM6750EVKMINI development board to the Internet through the ...
1 IntroductionAt present, the market for high-end dental chair equipment is basically dominated by foreign companies. Generally, they are expensive and the technology is not transferable. As people pa...
The lithium battery provides 3.3V voltage to the circuit system, and has USB charging function and overcharge protection function.USB charging is implemented using the TP4056 chip circuit. The TP4056 ...
[i=s]This post was last edited by Blue Angel on 2022-8-28 13:55[/i]The overall hardware framework structure is shown in the figure (attachment):
1. The constant current source and op amp design of the...
[align=left]With the rapid development of communication technology, the role of the network in daily work is becoming more and more important, and Ethernet has gradually become the communication basis...
stm32/stm8
京公网安备 11010802033920号
EEWORLD
