The common GPIO ports used on the development board are 4 LEDs, 1 button, and 3 enable pins U, V, and W. The Hall sensor is not used yet, so it is omitted.
1. Hardware circuit design
(1) Three enable ...
[i=s]This post was last edited by Jacktang on 2020-11-4 07:41[/i]Experimental resultsAfter installing the HC-PDA-ANDROID.apk software on the phone, the system is turned on. The phone can search for th...
When debugging the RL78 microcontroller, a problem was found that a driver IO could not be reset to zero.
But inserting a breakpoint found that it was possible, the solution steps are:Therefore, I sus...
1. Ensure that there is no firmware related to NIOS II in EPCS FLASH. This can be achieved by erasing the EPCS memory. Why do we need to erase it? If EPCS stores firmware related to NIOS II, it is pos...