[MCU September theme event]In September, when school starts and National Day is not far away, a wave of newbies will start their electronic exploration journey.
This month, the forum specially invited...
Preface
Previously, we used Qt to implement a ranger that fights tanks, but that was not enough. This time, we ported the NES emulator and turned the development board into a red and white game consol...
[i=s] This post was last edited by Digital Leaf on 2019-5-12 20:48 [/i] [size=4] According to the plan, I should have finished chapters 7 and 8 this week, but when I was actually operating the routine...
The earliest old-fashioned steam ovens used a float switch to detect the water level. The float switch uses the buoyancy of the float to drive the float, and the magnet drives the reed switch to achie...
[i=s]This post was last edited by Lam.lin on 2022-3-31 14:16[/i]Take MPS's MP8007 non-isolated solution as an example, Vin=48V, Vout=12V;Is the following understanding correct:① With VSS as the refere...
The following is a sampling circuit of a residual current detector for an IT power distribution system. It was copied from someone else's board. The circuit and device parameters in Figure 2 have been...