Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
I want to use an op amp to make a voltage attenuation circuit to measure 3~48V DC signals. Attached is a preliminary circuit diagram, but the power frequency interference problem cannot be solved duri...
An LED lamp at home is broken. This is a common 9W LED bulb. Since it cannot be used, I thought of disassembling it and analyzing it.It is easy to disassemble. Just squeeze the lampshade in front and ...
[align=left]Jialichuang has not produced gold-plated boards since 2008. In the actual trial process, 90% of the gold boards can be replaced by immersion gold boards. The poor weldability of gold-plate...
1. The electromagnetic flowmeter has no display 1. Check whether the power is on; 2. Check whether the power fuse is intact; 3. Check whether the power supply voltage meets the requirements; 4. Check...[Details]
From January 5th to January 8th, US time, at CES2023 (International Consumer Electronics Show) held in Las Vegas, USA, BOE made a strong appearance with a series of cutting-edge display technology pr...[Details]
The global semiconductor industry is facing a vicious cycle of shortages and price increases. Among them, the price increase of driver chips is the highest among all products in the industry. Since t...[Details]
Noise and energy efficiency are the main requirements for the development of low-power motor technology. As a motor development engineer, how do you choose a motor driver that is energy-efficient, qu...[Details]
Recently, according to foreign media reports, SK On, the battery business unit of SK Innovation, is considering developing lithium iron phosphate batteries. Previously, the company mainly manufacture...[Details]
Xinhua News Agency Client Shanghai, April 20 (Reporter Li Rong) Shanghai Brain-like Chip and On-Chip Intelligent System R&D and Transformation Functional Platform focuses on the semiconductor industr...[Details]
Product introduction: The DC/AC Micro Current Clamp K2 measures AC or DC currents down to 100µA. The output voltage signal mV is proportional to the measured current, which can be read directly on th...[Details]
Infrared remote control is the most widely used communication and remote control method. Since infrared remote control devices have the characteristics of small size, low power consumption, st...[Details]
Why did the Chinese home appliance market, which had been growing steadily in the past two years, suddenly decline? In recent days, the backstage of the home appliance circle has received a lot of ...[Details]
On July 1, after the staff's intensive acceptance and commissioning in the early stage, at 12:52, as the 10KV Beichu-201 circuit breaker cart was pushed into the designated position, the Beifang En...[Details]
AI-based machine learning techniques are already moving beyond cloud-based data centers as processing of vital IoT sensor data moves closer to where the data is created. The move will be enabled by...[Details]
The 4G version of Huawei's Mate 30 series was officially launched at 18:08 today (26), and Huawei Mall just announced in the evening that the sales of the Mate 30 series mobile phones exceeded 500 mi...[Details]
If the head and tail ends of the three-phase stator winding of the asynchronous motor are not marked or the markings are unclear, you can also use a pointer multimeter to use the residual magnetism m...[Details]
Infineon Technologies Launches SECORA™ Pay Green, World’s First Contactless Payment Card Technology, Reducing Plastic Waste by Up to 100%
SECORA™ Pay Green lays the foundation f...[Details]