After designing and simulating the device in HFSS, physical processing is required. Most PCB manufacturers do not accept HFSS files. You can export DXF CAD files to the manufacturers, but if the devic...
Why is SP set to 4096? How does it run after setting? Do you start writing from 4096 and then write to 4095 or 4097? Is 4096 the address of the steppingstone?Why is the interrupt set to 3072?
S3C2410 ...
In view of the current domestic and international situation and the gradual growth of domestic chips, it is recommended that this section cancel some unnecessary sub-sections, such as PIC, Atmel and o...
[i=s]This post was last edited by damiaa on 2019-1-3 16:08[/i] [font=Microsoft Yahei, Hei, Tahoma, SimHei, sans-serif][b]【NXP Rapid IoT Evaluation】Rapid IoT Studio Display and Touch Application[/b][/f...
Sometimes I need to play around with electronics but it’s really inconvenient without a heat gun at home. After some searching, it seems that only the 857DW from Kuake meets my requirements: small siz...