Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
# CCS compile error: unresolved symbols remain Solution: After CCS creates the project, add the DSPLib and MathLib you need to the basic CCS project framework:Put the above folder under the project, t...
Fiber Optic Project System Overview
--Author: Pan WenmingProject BackgroundThe optical fiber project is a project undertaken by MindYang from a research institute. The function of this project is to r...
I recently used the Bluetooth module HC-05. I first set the serial port baud rate to 38400, entered the AT command, and
Set the Bluetooth module to master mode, then power it on again, set the baud ra...
Question for the 12th Thinking Session
In the design example of the forward converter transformer given in Section 3.2.5 of Chapter 3 of "Mastering Switching Power Supply Design (2nd Edition)", whic...
This gray special effect of the website hinders all operations.
Neither IE nor Chrome works. In fact, whether to accept cookies, just click accept, and that's it. All operations are blocked....
PLCs of all brands have a self-diagnosis function, but the trick to PLC repair is to make full use of this function to analyze and then accurately find the problem. We have sorted out 8 common erro...[Details]
China's automobile industry is entering a critical transformation and reconstruction cycle of the intelligent supply chain, and players from all walks of life are competing for the few tickets to the...[Details]
Trimble, a global positioning solutions provider, announced the first deployment of its map-based positioning system, Applanix POS LV, for land-based autonomous vehicle applications. Japanese heavy i...[Details]
1. Selection of devices There are many circuits and corresponding PC download software for making parallel port ISP download on the Internet. Many people are confused and don't know which picture t...[Details]
The power battery of new energy vehicles is different from the engine of fuel vehicles. Due to physical limitations, it is difficult for power batteries to achieve revolutionary changes in a short pe...[Details]
A phenomenal product is rewriting the landscape of China's color TV market. The latest issue of the China Market Research Color TV Retail Analysis Weekly Report has been released. As of November 24, ...[Details]
On April 14, it was reported that this is China's largest autonomous driving car data center and Asia's largest Robotaxi (autonomous driving taxi) operation center. Recently, AutoX , a global lead...[Details]
Zou Zuoji, Regional Vice President of UiPath Greater China*
Working with a robot assistant may sound like science fiction, but in 2022 it will be closer to reality than you...[Details]
This article will focus on the working principle, product features and performance of digital isolators, and then explain
some applications of
digital isolators
in electronic products.
1. Wo...[Details]
The problem of frequency converter speed regulation generally includes stepped speed regulation and stepless speed regulation.
Stepped speed regulation means that the frequency of the inverter...[Details]
Aiming at the low-voltage DC input and high-voltage DC output power supply equipment required in some special occasions, a circuit of low-voltage DC-DC boost conversion based on the double-end push-pu...[Details]
This article mainly solves many problems of eCos configuration tool running on Ubuntu 64bit.
I'll post the screenshots first, otherwise you'll get a headache when you see the code and won't se...[Details]
Radio frequency identification technology RFID is a non-contact automatic identification technology. Its basic principle is to use the transmission characteristics of radio frequency signals and spat...[Details]
As the energy crisis and environmental problems continue to deepen, the development of new energy has attracted more and more attention. In recent years, with the strong support of national policies,...[Details]
We have conducted a comprehensive inspection of the safety quality and equipment configuration of the energy storage project. No abnormalities have been found so far, and it can be put into operation ...[Details]
Innovation Lab
京公网安备 11010802033920号
EEWORLD
