Features ....................................................................................................................................................................................... 1
Typical Phase Jitter (70 fs RMS) and Phase Noise Data ............................................................................................................. 2
Ordering Information .................................................................................................................................................................... 3
LVPECL and FlexSwing Termination .................................................................................................................................. 19
LVDS, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 20
HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 20
Low-power HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V .................... 20
Dimensions and Patterns ― 2.0 x 1.6 mm x mm ....................................................................................................................... 21
Dimensions and Patterns ― 2.5 x 2.0 mm x mm ....................................................................................................................... 22
Dimensions and Patterns ― 3.2 x 2.5 mm x mm ....................................................................................................................... 23
Revision History ......................................................................................................................................................................... 24
Rev 0.54
Page 4 of 25
www.sitime.com
SiT9501
Ultra-low Jitter Differential XO for Standard Networking Frequencies
Electrical Characteristics
ADVANCED
All Min and Max limits in the Electrical Characteristics tables are specified over operating temperature and rated operating
voltage with standard output termination shown in the termination diagrams. Typical values are at 25°C and nominal
supply voltage.
Table 3. Electrical Characteristics – Common to All Output Signaling Types
Parameter
Output Frequency Range
Symbol
f
Min.
Typ.
Max.
Unit
MHz
Condition
Refer to frequencies listed in
Error! Not a valid result for table.
s
ection.
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and 10 years
aging at 25°C
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and first year aging
at 25°C
Ambient temperature of 25°C
Extended commercial, ambient temperature
Industrial, ambient temperature
Ambient temperature
Extended industrial, ambient temperature
Voltage-supply order code “YY”
Voltage-supply order code “XX”
Voltage-supply order code “18”.
Contact SiTime
for 1.5 V
Voltage-supply order code “25”
Voltage-supply order code “33”
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
See
Figure 6
and
Figure 8
Measured from the time Vdd reaches its rated minimum value
Measured from the time OE pin toggles to enable logic level to
the time clock pins reach 90% of swing. See
Figure 13
Measured from the time OE pin toggles to disable logic level to
the last clock edge. See
Figure 14
12 kHz to 20 MHz offset frequency integration bandwidth
"PWM Control and Driver User Guide and Application Circuits - SPWM, PFC and IGBT Control and Driver Part" is divided into 3 chapters, collecting more than 30 types of the most widely used and most wid...
= =A bit worried that the description is not clear
High LO: 10700MHz,Low LO: 9750MHz(can be set, such as 5150 for single LO)
The intermediate frequency is 950~2150MHz.
I use an instrument (SFC) to tes...
MPS isolation solutions support various isolation requirements and maximize system safety levels, with industry-leading performance and small packages. Learn about MPS isolation solutions and answer q...
About Speed SensorThe speed sensor is mainly used to detect the engine speed and vehicle speed. The engine speed detection is based on the same principle as the crankshaft position detection, but in o...
Building a ubiquitous power Internet of Things to boost energy revolution
——Interview with Kou Wei, Chairman and Party Secretary of State Grid Corporation of China
In today's world, the e...[Details]
OFweek Cup · OFweek 2023 China
Robot
Industry Annual Selection (abbreviated as OFweek Robot Awards 2023) is jointly organized by OFweek, China's high-tech industry portal, and its authorita...[Details]
"The more you discharge a lithium-ion battery, the more it wears out," said Tom Hartley, an electrical engineering professor at the University of Akron who helps NASA study ways to extend battery l...[Details]
The cooling fan of a car engine is an important part of the vehicle cooling system. If the fan fails, it will lead to insufficient or excessive cooling of the engine, causing the engine working envir...[Details]
There are only 6 registers in the STM8 CPU, namely A, X, Y, SP, PC, and CC. Complete the addition of two 8-bit unsigned numbers in the memory and save the result in the memory. unsigned char a,b,c; c...[Details]
Some people may have encountered the situation where the laptop is plugged in but the battery is not charged. Here are some common solutions.
Power mode settings
If you set the longes...[Details]
Recently, according to Tianyancha, Shanghai Zhizhunxin Semiconductor Technology Co., Ltd. completed a B round of financing of hundreds of millions of RMB. The investors include Meituan, GGV Capital,...[Details]
With the rapid development of my country's economy, the continuous increase in urban and rural residents' income and the large increase in leisure time, tourism consumption has entered a new stage of...[Details]
Divide the coil into two parts: the coil and the electric shock. Use electricity to block the resistance. You can simply measure the resistance of the coil. Generally, it is tens to thousands of ohms...[Details]
Tianyancha App shows that Jiangsu Changjing Technology Co., Ltd. has recently undergone a number of industrial and commercial changes, with nine new investors including Hubei Xiaomi Changjiang Indust...[Details]
ADI holds Open RAN Policy Alliance exchange event Beijing, China—March 2, 2023—Recently, Analog Devices, Inc. (ADI) held an Open Radio Access Network (Open RAN) Policy Alliance (ORPC) exchange eve...[Details]
International Energy Network/PV Headlines (PV-2005) learned that on June 21, the winning bidders for the string photovoltaic inverter equipment procurement for China Resources Power Shilin Dadilian...[Details]