Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[size=4][color=#000000][backcolor=white]Impedance matching is a common concept in high-frequency design. This article provides a good analysis of this "impedance matching". It answers what impedance m...
(1) Memory expansion: Capacity requirements. When selecting, the internal memory resources of the MCU should be considered. If the requirements can be met, there is no need to expand. When expansion i...
A photo of five cute cats huddled together on a "satellite dish" to keep warm in the snow has recently become a hit on foreign social media. According to a report by the British newspaper The Guardian...
Does anyone have a good method for 4.2V disconnection monitoring?When the current is set at 30K, according to the formula in the specification, the constant current charging current is 1000/30000=33mA...
We hope to control the intan 2132 headstage through the SPI interface based on STM32MP157-DK1. Weonly need to implement data reading with a sampling rate of 10KHZ.If you are interested, please contact...
Analogue and Mixed Signal
京公网安备 11010802033920号
EEWORLD
