Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
Although it is posted here, the title is no joke.
I've recently been trying to embark on the path of freelancing.I can write code, boards, and soft manuscripts.
If you need anything, please find me~~~...
The following code resets ICE40LP1K, but it is found that the CDONE pin is always at a low level and will not be pulled high. Is there any other initialization operation?uint32_t fpga_reset(){fpga_ini...
A netizen answered a post about the daily schedule of a tech company.A Taiwanese netizen said that his daily routine used to be as follows:09:00 Arrive at the company and swipe your card09:20 Eat brea...
Problem: The audio file is blocked from playing in a loop, and the screen cannot refresh the image captured by the camera in real time (there is a "stuck picture"). Try to use the state machine to pla...
[i=s] This post was last edited by qq825117996 on 2020-9-3 11:12[/i]void MX_TIM7_Init(void)
{LL_TIM_InitTypeDef TIM_InitStruct = {0};/* Peripheral clock enable */LL_APB1_GRP1_EnableClock(LL_APB1_GRP1_...
In electronically controlled gasoline injection engines, the oxygen sensor used for closed-loop control of the fuel system is an important electronic component that monitors the oxygen content in t...[Details]
Only by running into the widest industry track can you share the thickest profit space. The firmness and rapid pace of Jinyuan's transformation to lithium resources is quite rare in the entire capi...[Details]
2051 comparator analog AD source program (C language) /* io allocation: * ;* OUTPUT: * ;* P1.0 ...... analog input * ;* P1.1 ...... DA input comparison reference voltage * ;* P1.2~7..... R-2R DA ...[Details]
Commonly used three-wire sensors, whether NPN or PNP, can be measured directly with a multimeter. The sensor, 24V power supply and multimeter form a circuit, and the multimeter is set to the DC...[Details]
According to news on June 8, the World Semiconductor Trade Statistics (WSTS) recently released a forecast that the global semiconductor market size will decrease by 10.3% year-on-year in 2023 to US$5...[Details]
Standard development board: Atom STM32F103RBT6
SPI: The four lines MISO, MOSI, SCLK, CS are a high-speed, full-duplex, communication bus. Reading and writing are done at the same time. If you only wa...[Details]
Recently, BYD released the "Blade Battery", which has caused a great response in the industry and its stock price has also risen significantly. So what is BYD's "Blade Battery" and what are its advan...[Details]
During the measurement process of the eddy current sensor, some conditions of the measured object will affect the entire measurement process. Can you tell me which factors of the measured object will...[Details]
Differential pair tube detection method
The differential pair is a semiconductor device that packages two transistors with the same performance into one. It can form a dif...[Details]
introduction
In digital communications systems, the received signal-to-noise power spectral density ratio (Pr/N0), the received bit energy to noise power spectral density ratio (Eb/N0), and ...[Details]
On June 21, Twitter whistleblower @Teme pointed out that the Mate40 Pro will use a UTD screen designed specifically for folding screen and ultra-curved display phones. According to previous plans, ...[Details]
/****** The MCU receives the command from the computer serial port and executes the corresponding action. At the same time, it also receives the signal from the wireless remote control and executes...[Details]
Although the exam is approaching, I still managed to master the basic operation of DDS in the time, O(∩_∩)O hahaha. From understanding the theoretical principles to downloading and debugging the wave...[Details]
MEMS sensors
京公网安备 11010802033920号
EEWORLD
