ULTRA LEVEL TECH CO., LTD.
www.ultralevel.com.tw
Tel:+886-2-29180118
Fax:+886-2-29181465
We Supply the Power Customers Need
ISO9001
FEATURES:
170W ~ 320W AC-DC SWITCHING POWER SUPPLY
RL0601 SINGLE OUTPUT SERIES
◆
Compact 320W with 1U height Power Density: 8.9 watts/cu in
◆
Low Leakage Current 500uA @ 240Vac / 300uA @ 120Vac
◆
Power Factor Corrected to EN61000-3-2 class A
◆
Peak Power 700W within 500uS Duty Duration
◆
Variable Fan Speed & Low Acoustical Noise
◆
High Quality & Reliable Component Usage
◆
Approved to UL CUL TUV CB and CE.
◆
AC Input Range Auto-Selectable
◆
Output Voltages from 2 ~ 60Vdc
◆
4 - Mechanical Options
E Type:
7(L) x 4(W) x 1.6(H) inches.
U Type:
6(L) x 4(W) x 1.5(H) inches.
F Type:
6(L) x 4(W) x 2(H) inches.
C Type:
6(L) x 4(W) x 1.55(H) inches.
PRODUCT SPECIFICATIONS:
Input Voltage:
90-132 / 180-264Vac auto-ranging, 47~63Hz.
Input Current:
8/4A at 100-120/200-240Vac.
Inrush Current:
Max. 70A@230Vac & 35A@115Vac; cold start.
PFC:
Power Factor Correction pass EN61000-3-2 class A.
Transient Response:
Returns to within 1% in less than 2.5mS for a
50% load change and the peak transient does not excess 5%.
Overshoot:
Turn-on & off overshoot < 5% over nominal voltage.
Efficiency
70% ~ 85% depends on model.
Turn On Delay:
1 second maximum at 230 Vac.
Hold Up Time:
20mS min. at 80% of full load.
Adjustability:
Output user adjustable +/-5% minimum.
Fan Drive:
12VDC/400mA offering to drive an external fan.
Fan Fail (FF) Alarm:
Designated as
FF
on pin 3 of CN1, two types
of logical signal provided, contact manufacturer.
Power Supply On:
Green LED designated as
LED1
on the PCB.
Power Good: PG
on CN1 goes high 100-500mS after DC regulation
and low at least 1mS before loss of regulation (Open collector).
Input Fusing Protection:
One T8AL250V fuse inserted in primary.
Over-Power Protection:
110~140% of I-Max; Auto-recovery.
Short Circuit Protection:
Trip without damage and auto-recovery.
Over Voltage Protection:
Unit latching down when output exceed
130% and recycle AC input to reset.
Over-Temperature Protection:
Unit protected of excessive
operating ambient 110
℃,
and automatic recovery.
Switching Frequency:
23K Hz fixed frequency.
Operating Temperature:
0℃ to 70℃ ambient, de-rating at 2.5% per
degree from 50℃ to 70℃.
Warranty:
2 years.
Storage Temperature:
-20 to 85
℃.
CB
Vibration:
5 ~ 50 Hz, acceleration 7.35 m/s*s on X,Y and Z Axis.
Operating Humidity:
5% to 90% RH, Non-condensing.
Storage Humidity:
5% to 95% RH, Non-condensing.
EMC:
EN55022 class B conducted / radiated, EN61000-3-2,
EN61000-3-3; EN55024 (IEC61000-4-2, IEC61000-4-3, IEC61000-
4-4, IEC61000-4-5, IEC61000-4-6, IEC61000-4-11).
Safety Regulation:
UL60950-1, EN60950-1, IEC60950-1.
Leakage Current:
< 1mA @ 264Vac.
(optional for 500uA max. at 240Vac / 300uA max. at 120Vac input)
HI-POT Test:
1500 VAC input line to chassis (10mA DC cut off
current); Isolating 3000VAC primary to secondary windings;
Primary to core 1500VAC. All for 3 sec.
Grounding Test:
Apply 25 A from ground pin of the three prong
plug to the far most earth. Max allowable resistance 0.1 ohm.
MTBF:
100000 Hrs (according to MIL-HBK-217F) at 30
℃
.
Cooling:
U Type: U-Chassis @320W max. with 22CFM max. forced airflow
or 180W convection cooled output.
C Type: U-Chassis with top cover @170W max. convection cooled.
E Type: Enclosed with rear side built-in fan @320W max.
F Type: Enclosed with top built-in fan @320W max.
Enclosure:
U Type: 6(L) x 4(W) x 1.5(H) inches.
C Type: 6(L) x 4(W) x 1.55(H) inches.
E Type: 7(L) x 4(W) x 1.6(H) inches.
F Type: 6(L) x 4(W) x 2(H)inches.
Burn in:
45 +/- 5 degree C for 1 hour @230Vac with full load.
Weight:
Maximum weight is 800g.
Copy Right Ultra Level Tech Co., Ltd 2015, All Right Reserved. Specifications subject to change without notice.
ULTRA LEVEL TECH CO., LTD.
www.ultralevel.com.tw
Tel:+886-2-29180118
Fax:+886-2-29181465
We Supply the Power Customers Need
ISO9001
OUTPUT VOLTAGE / CURRENT RATING CHART:
Measured at output power connector.
Max. Output Power or Current
Model
RL0601x-05
RL0601x-09
RL0601x-12
RL0601x-15
RL0601x-18
RL0601x-24
RL0601x-28
RL0601x-36
RL0601x-48
RL0601x-54
Output
Range
2 ~ 5.5V
6 ~ 11V
12 ~ 13.5V
13.6 ~ 15V
16 ~ 20V
21 ~ 26V
27 ~ 34V
35 ~ 42V
43 ~ 50V
51 ~ 60V
Preset
Voltage
5V
9V
12 V
15 V
18V
24V
28V
36V
48V
54V
Type U (forced air)
&E&F
45A
29.1A
320W
320W
320W
320W
320W
320W
320W
320W
Type U
(Convection)
27.28A
16.37A
180W
180W
180W
180W
180W
180W
180W
180W
Type C
(Convection)
25A
13.64A
170W
170W
170W
170W
170W
170W
170W
170W
Regulation
+/- 1%
+/- 1%
+/- 1%
+/- 1%
+/- 1%
+/- 1%
+/- 1%
+/- 1%
+/- 1%
+/- 1%
Ripple
& Noise
50mV
1%
1%
1%
1%
1%
1%
1%
1%
1%
Note:
* RL0601 series are designated as RL0601x-y where x can be
E
(Enclosed Type with rear side built-in fan) or
F
(Enclosed Type with top side
built-in fan) or
U
(U-Chassis Type) or
C
(U-Chassis Type with top cover), y can be
05, 09, 12, 15, 18, 24, 28, 36, 48, 54.
*
RL0601U Series:
U-Chassis @320W max. with 22CFM max. forced airflow is required to model RL0601U-05 and
18 CFM for other models or 180W convection cooled output.
*
RL0601C Series:
U-Chassis @170W max. convection cooled.
*
RL0601E Series:
Enclosed with rear side built-in fan @320W max.
*
RL0601F Series:
Enclosed with top built-in fan @320W max.
* All output range are covered in agencies certification and the preset voltage will be set as standard models if any request is not preset
output then should contact us in advance.
* Ripple and noise is measured from 10KHZ to 20MHz bandwidth at output with parallel 0.1µF ceramic and 22µF electrolytic capacitors.
* Providing peak power to 700W within 500uS for all models, longer duty duration need contact manufacture.
* 1% minimum load is required to maintain the ripple and regulation.
* Output is fully isolated.
OUTLINE DRAWING:
Input and Output Connector (CN2):
Terminal block - Howder Part No. HB-95-7P
Molex - Mating JST VH series. Input 5 pin connector (3 pin used, pin 2 & pin 4 removed), PCB
labeling: L = Line; N = Neutral; G = Chassis Ground. Output 10 pin connector.
Input and Output Connector Pin Assignment:
(See table in right).
Mounting Inserts:
6 Places 8-32 (M4X0.7 Optional). Maximum Penetration 4mm sees outline drawing for location.
Logic signal connector (CN1):
Mating JST XHP-3 or equivalent (CHYAO SHIUNN JS-2001-03);
Mating Pins: JST SXH-002T-P0.6 FOR AWG 30 to 26.
Fan driver connector (FAN2):
Mating connector is JST P/N XHP-2 (2 pins 0.98 pitch) or equivalent (CHYAO SHIUNN JS-
2001-02).
Howder
Pins 1 ~ 2: V+
Pins 3 ~ 4: V-
Pin 5: GND
Pin 6: Neutral
Pin 7: Line
Molex
Pins 1 ~ 5: V+
Pins 6 ~ 10: V-
Pin 11: GND
Pin 13: Neutral
Pin 15: Line
Copy Right Ultra Level Tech Co., Ltd 2015, All Right Reserved. Specifications subject to change without notice.
Analog electronics
京公网安备 11010802033920号
EEWORLD
