[size=4] For those who work on power electronics software, there is usually not much code in this line, and it often takes several months to adjust a few lines of code, such as grid-connected algorith...
A 100W/200R cement resistor is connected to the J14 load. I checked the power meter and found that the load power is less than 1W. The voltage given by PC6 is 3.3V. The meter shows that there is a cur...
As shown in the figure, the wiring method of the bidirectional thyristor in the circuit is that because it is bidirectional, I swapped T2 and T1. The thyristor was always in the on state and could not...
First of all, I wish you all a happy Chinese New Year. This year can actually be described as "turbulent". Electronic technology and chips have become the top search terms in 2019. Every fluctuation i...
How to use NE555 to build a square wave signal with a duty cycle of 50%, a signal amplitude of -5V~+5V, and an adjustable frequency (1khz~50khz). I have only learned the basics of circuit analysis and...
As shown in the picture, the actual boost voltage of the ME2139 DC-DC boost IC I used is 4.8V, and the current it can withstand is 2.5A. There is a series heating wire (2.5R) in the COIL, and I connec...
DSP and ARM Processors
京公网安备 11010802033920号
EEWORLD
