-
The LTC1588/LTC1589/LTC1592 are serial input current output 12-/14-/16-bit multiplying DACs that operate from a single 5V supply. These SoftSpan™ DACs are software programmable for either unipolar ...[Details]
-
3.1 include/configs/micro2440.h
delete
#define CONFIG_CS8900 /* we have a CS8900 on-board */
#define CONFIG_CS8900_BASE 0x19000300
#define CONFIG_CS8900_BUS16 /* the Linux driver d...[Details]
-
The online power quality monitoring equipment is the most basic and most important equipment in the power quality supervision and detection network of the power grid. At present, most of the monitorin...[Details]
-
How to judge whether the wire displacement encoder is good or bad during use? The simplest way is to connect the wires according to the wiring definition in the product manual. If there is no pulse o...[Details]
-
Introduction
(Mixed-Signal FPGA Controls Voltage Ramp Rates in Multi-Level Systems): As process geometries continue to shrink, devices often require multiple power supplies. To reduce power c...[Details]
-
The low-power power
adapter
discussed in this article
is mainly for
power supply
systems with an output power of 5 to 15 watts. There are two main types of solutions, namely integrat...[Details]
-
According to EETimes, UK-based IP supplier UltraSoC recently announced that it has received a new round of financing of 5 million pounds. The funds will be used to develop hardware-level network secu...[Details]
-
1. Interruption (ii) Timer and counter interrupts The lower eight bits of TL0 are stored first, and when they reach 0XF, they are incremented until the upper and lower eight bits are full, ...[Details]
-
1. Market Status At present, digital AC servo systems are widely used in some motion control systems that require high positioning accuracy or dynamic response. The driver of this servo system sam...[Details]
-
Application of on-line monitoring and infrared diagnosis in transformer fault analysis
Abstract
With the vigorous development of power construction, the capacity and vo...[Details]
-
1 Overview of power transformer fault diagnosis methods
Traditional power transformer fault diagnosis methods have their own limitations: the parameter model theory based on the neutral po...[Details]
-
When using STVP to program stm8, the erase option is always grayed out. Erasing method: Step 1: In OPTION BYTE, set the ROP option to Read Out Protection ON, and then burn (select Program, Curren...[Details]
-
Hengdian Dongmei recently stated at an online investor exchange meeting that the 6GWh lithium battery project is expected to be completed and put into production by the end of this year. The main tas...[Details]
-
According to the iPhone 13 Pro cost analysis released by the third-party disassembly agency iFixit, the total BOM cost of the iPhone 13 Pro is US$570, approximately RMB 3,674. The BOM cost of the iPh...[Details]
-
Nowadays, many pointer multimeters have the function of measuring AC current, but there are also many analog multimeters that only have the function of measuring DC current. In order to meet the meas...[Details]
Test/Measurement
京公网安备 11010802033920号
EEWORLD