Pb in high temperature solder (exempt per RoHS 2002/95/EC Annex (7))
Obsolete/End of Life Date: 12/31/2014 – Last Time Buy Date: March 31,2015
ABSM2
RoHS/RoHS II Compliant
12.5 x 4.6 x 3.7mm
| | | | | | | | | | | | |
| |
Please consider ABSM3A as an alternative
FEATURES:
• Suitable for RoHS compliant reflow
• Available tight tolerance and
temperature stability
STANDARD SPECIFICATIONS:
Parameters
Available Frequencies
Operation Mode
Operating Temperature
Storage Temperature
Frequency Tolerance @+25°C
Frequency Stability over the Operating
Temperature ( ref. to +25°C)
Equivalent series resistance (R1)
Shunt capacitance (C0)
Load capacitance (CL)
Drive Level
Aging
Insulation Resistance
Table 1. Standard ESR
Frequency (MHz)
3.50 - 3.999
4.000 - 5.999
6.000 - 11.999
12.000 - 32.000 (fund)
30.000 - 35.999 (3rd overtone)
33.000 - 70.000 (3rd overtone)
ESR (Ω)
max.
200
150
100
50
100
80
APPLICATIONS:
• Computers, Modems, Microprocessors
• Communication, Test equipment
• PCMCIA
Units
MHz
-----
-----
-----
ºC
ºC
ppm
ppm
Ω
pF
pF
µW
ppm
MΩ
Notes
3.50 MHz - 30.000 MHz
30.001 MHz - 70.000 MHz
30.001 MHz - 32.000 MHz
Minimum
Typical
Maximum
See Table 2 below
Fundamental:
Standard
3rd Overtone:
Standard
Fundamental:
Option.
See options below
-10
-----
+60
-55
-----
+125
-50
-----
+50
-50
-----
-----
-----
-5
500
Table 2
See options
See options
See options
-----
See table 1 below
-----
18.0
-----
-----
-----
+50
7.0
-----
100
+5
-----
Standard
(See options if
other than STD)
@25°C±3°C
First year
@ 100Vdc ± 15V
Available Frequency List [MHz]
3.579545
3.686400
3.932160
4.000000
4.032000
4.096000
4.194304
4.433619
4.800000
4.915200
5.000000
5.068800
5.120000
5.333333
5.529600
6.000000
6.144000
6.176000
6.400000
7.159090
7.372800
7.680000
8.000000
8.000156
8.192000
9.216000
9.600000
9.830400
10.000000
10.240000
10.240000
11.000000
11.059200
11.289600
12.000000
12.288000
12.352000
12.500000
13.000000
13.500000
14.318180
15.000000
15.360000
16.000000
16.000312
16.257000
16.384000
16.666000
16.667000
16.934400
16.934400
17.734475
18.000000
18.432000
18.869600
19.440000
19.660800
20.000000
20.480000
22.118400
24.000000
24.000140
24.576000
24.704000
25.000000
25.175000
27.000000
28.000000
28.322000
28.636360
29.491200
29.500000
30.000000
32.000000
32.768000
33.000000
33.333000
33.333300
33.868800
34.000000
35.468950
36.000000
40.000000
40.960000
44.000000
45.000000
47.940000
48.000000
48.000000
49.152000
50.000000
53.125000
55.000000
60.000000
64.000000
66.000000
66.666600
9.830000
14.745600 19.200000
(Left blank if standard)
OPTIONS & PART IDENTIFICATION:
ABSM2 -
Frequency in MHz*
Please specify the
frequency in MHz.
e.g. 16.000MHz
Load Capacitance (pF)*
Please specify CL (min
10pF) in pF or S for series
Custom ESR if other
than standard
R□
□:
Specify a value in
Ω
(e.g.: R40)
Operating Temp. *
E: 0°C to +70°C
B: -20°C to +70°C
C: -30°C to +70°C
N: -30°C to +85°C
D: -40°C to +85°C
Freq. Tolerance*
4: ± 30 ppm
MHz -
-
-
-
-
Packaging
Blank: Bulk
T: 1000pcs/reel
Oscillation Mode
F: Fundamental AT for
30MHz<F<32MHz
Freq. Stability*
Y: ± 30 ppm
H: ± 35 ppm
Z: ± 100 ppm
R: ± 150 ppm
*Frequency, Load Capacitance, Frequency
tolerance and stability is subject to availability.
Please contact Abracon for each option for
availability.
ABRACON IS
ISO9001:2008
CERTIFIED
CE RTIFIED
LLC
2 Faraday, Suite# B
|
Irvine
|
CA 92618
Revised:10.12.15
Ph. 949.546.8000
|
Fax. 949.546.8001
Visit
www.abracon.com
for Terms and Conditions of Sale
MOLDED PLASTIC SMD MICROPROCESSOR CRYSTAL
ABSM2
OUTLINE DRAWING:
Pb in high temperature solder (exempt per RoHS 2002/95/EC Annex (7))
RoHS/RoHS II Compliant
12.5 x 4.6 x 3.7mm
| | | | | | | | | | | | |
| |
Dimensions: Inches (mm)
TAPE & REEL:
T=Tape and reel (1000pcs/reel)
REFLOW PROFILE:
Dimensions: mm
ATTENTION:
Abracon Corporation’s products are COTS – Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated,
Automotive Applications. Abracon’s products are not specifically designed for Military, Aviation, Aerospace, Life-dependant Medical applications or any application
requiring high reliability where component failure could result in loss of life and/or property. For applications requiring high reliability and/or presenting an extreme
operating environment, written consent and authorization from Abracon Corporation is required. Please contact Abracon Corporation for more information.
In the C:\Texas Instruments\Z-Stack Home 1.2.2a.44539\Components\stack\zdo\ZDApp.h file of the Z-Stack Home 1.2.2a protocol stack, the different states of the device are defined as follows.typedef enu...
This evaluation experiment tests the CAN module communication error handling mechanism.The CAN general specification stipulates that each CAN controller has a send error counter and a receive error co...
Now everyone has a smart phone, and WeChat applet is very convenient to use. This project finally communicates with RSL10 Bluetooth SoC through WeChat applet. Since I have never been involved in WeCha...
dql2016onsemi and Avnet IoT Innovation Design Competition
First, pay attention to a few issues: 1. During SPI communication, the timing (phase, polarity) of both parties must be consistent (see the following four SPI timing settings) 2. The host sets the clo...
1. Introduction
N32L43X supports two advanced timers, TIM1 and TIM8. The advanced timer supports input capture, output comparison, PWM, dead zone, brake and other functions. This article mainly tests ...
In the laser power supply, the functions of the synchronization signal source are as follows: 1. Generate a trigger pulse for the discharge switch of the main discharge circuit. If the pulse laser wo...[Details]
The development history of the information and communication technology industry is also a history of the growth of domestic basic software and hardware companies. The information and inno...[Details]
On June 27, the Shanghai Regulatory Bureau recently disclosed that Doxin Semiconductor signed the "Guidance Agreement on the Issuance and Listing of Doxin Semiconductor Co., Ltd.'s Shares" with Haito...[Details]
IT Home May 2 news According to foreign media Windows Latest, Microsoft will release Surface Go 2 in May, and related hardware specifications have been leaked. According to the retailer's list, Su...[Details]
The circuit triggers at a level of 1/3 VCC upon receipt of a pulse at pin 2. Once triggered, the circuit will remain inactive until the set time has elapsed or the circuit power is cut off. The delay...[Details]
Last week, well-known analyst Ming-Chi Kuo revealed that the cost of the iPhone 12 series is high, causing speculation from the outside world as to whether the price will rise. However, the l...[Details]
All external pins of STM32 built-in peripherals are multiplexed with standard GPIO pins. For example, for STM32F103VBT6, pin 47 is PB10, and its multiplexed functions are I2C2_SCL and USART3_TX, which...[Details]
In this testing article, we will cover checking. In this section, you will ensure that the design meets the efficiency standards and other required specifications such as line and load, ripple, trans...[Details]
EEPROM Overview Electrically Erasable Read-Only Memory (EEPROM) can store information for a long time without volatile memory and can be rewritten by electricity at any time. There are many types of ...[Details]
Today I tested the PWM wave output of the TIM timer of stm32F407 and learned about its configuration process. The main points are as follows:
1. Enabling the multiplexing function of GPIO refers to 1...[Details]
The internal 128K low-speed clock of stm8s105k6 needs to be used, and the debugging is not very smooth, so I would like to record it. Switch from the internal 16M clock to the internal 128K clock, ...[Details]
Apple CEO Tim Cook said that despite being released only in November last year, sales of MacBook Air, MacBook Pro and Mac mini equipped with M1 processors now account for the majority of Mac sales, s...[Details]
Despite years of development, there has been no breakthrough in the density of lithium batteries. The extremely scarce space in mobile phones cannot accommodate a battery that is too large. ...[Details]
According to my observation, the competition in the mobile phone industry chain has gradually turned into competition among listed companies since the past two years. At the same time, more upstream ...[Details]
1. Interrupt handling architecture
The Linux kernel unifies the numbers of all interrupts and uses an array of irq_desc structures to describe these interrupts.
The array is d...[Details]
Wireless Connectivity
京公网安备 11010802033920号
EEWORLD
