Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
The function is: send a character (such as e) to the microcontroller, and then the microcontroller returns the string "I get e", serial port communication.
Copy code#include reg52.h#include intrins.h
...
[i=s]This post was last edited by jinyi7016 on 2022-10-31 10:59[/i]First of all, EEWORLD and DFRobot chose me to try out these Xingkong boards.
After receiving the development board, unpack and start ...
There are four commonly used delay methods in C language, as shown in Figure 4-2.Figure 2-4 C language delay methodFigure 4-2 shows four common delay methods used in C language programming, two of whi...
Since there is only one user key on board, it is very limited when setting parameters. For this reason, it can be equipped with a membrane soft key for key expansion. The membrane key has a total of 4...
[size=4] What is the initial value of the RAM inside the MCU after it is powered on? What are its characteristics and rules? Today, I will share with you some of the problems I encountered in the proc...
The repair of used batteries will be kept secret for now. Please see the automatic charging picture. 1: At the beginning of charging, if the battery can be charged with a large current, it will automa...
0 Preface
At present, leakage protectors are widely used as a new type of low-voltage protection electrical appliance, both in cities and in rural areas. The reliability of their work directly affe...[Details]
Electric vehicle charging facility construction and operation companies in Haikou:
In order to implement the "Implementation Opinions of the Hainan Provincial People's Government on Vigorously...[Details]
The keyboard must be with a common terminal class - and for each key a separate connection. A 12-key keyboard - 13. A matrix type with 7 or 8 terminals will not work. On the support page you will...[Details]
5G Technology Devices for an O-RAN Wireless Solution 5G technology components for implementing O-RAN wireless solutions Summary O-RAN aims to transform the wireless community, open up new wire...[Details]
On July 13, Mr. Wu Yongqiang, Chairman of Tuobang Co., Ltd. (hereinafter referred to as "Tuobang"), was invited to attend the Huizhou New Energy Storage Industry Development Promotion Conference. H...[Details]
There are many different brands of wire harness testers on the market. The wire harness test instruments produced by different developers not only have large differences in price, but also have compl...[Details]
Zhang Yucheng, market product manager of HMD Nokia mobile phones in China, revealed in an interaction with netizens on Weibo that Nokia's new 5G phone in China may be released before November 11 this...[Details]
Tencent TAI automotive intelligent system has finally joined the battle of joint venture brands. As the first joint venture brand model equipped with Tencent TAI car intelligent system, Ford Territ...[Details]
United Electronics' first electric bridge product rolled off the production line Independent research and development, integrated design Excellent performance, efficiency up to 93% Safe an...[Details]
We have been talking about wireless for several years now, but if you look closely, you will find that we are already living in a wireless world. In the early 1990s, mobile phones were mainly used ...[Details]
Contestants measure the voltage waveform at the output port of the signal generator Problem analysis: Use a signal displayed on the oscilloscope to ask whether the corresponding electromagnetic wire ...[Details]
Arteris system IP facilitates the seamless integration of functional safety solutions in automotive systems. exida has successfully completed ISO 26262 functional safety certification for Ncore...[Details]
LeTV held a performance briefing for 2018, where LeTV Chairman Liu Shuqing, General Manager Zhang Wei, and Board Secretary Bai Bing responded to issues of concern to investors. At the briefing, whe...[Details]
Because it involves programming, learning ARM single-chip microcomputer system is somewhat difficult for designers engaged in electronic circuits. Learning knowledge is not difficult, but it is diffi...[Details]
Abstract: In wireless sensor networks, the overall performance of the network depends on the communication module on the node. Based on the actual needs, this paper selects
the
CC1100
chip w...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
