-
According to foreign media reports, Ford announced a collaboration with Ansys in the United States. By adopting Ansys' simulation solutions, Ford can accelerate the development of its predictive smar...[Details]
-
Hardware Connection Diagram of Microcontroller Serial Port Communication Programming Example: Use the 8051 microcontroller serial port to connect to the CD4094 to expand the 8-bit parallel output...[Details]
-
What is the structure of a microcontroller and what modules it consists of The full name of Micro Control Unit is microcontroller (MCU). From the literal meaning, we can understand that it is actua...[Details]
-
The serial port of MCS-51 is a full-duplex asynchronous serial communication interface that can send and receive data at the same time. There are data receiving buffer and data sending buffer ...[Details]
-
The schematic diagram of the LED module of the development board is as follows: By declaring a bit variable, the level of P2^0 port is set to 0, and the first LED can be lit. Procedure 1 is as fo...[Details]
-
#define LED0_PWM_VAL TIM3- CCR2 //Comparison register (TIM3 channel 2), can adjust the PWM duty cycle, int main(void) { u16 led0pwmval=0; u8 dir=1; Stm32_Clock_Init(9); //System clock setting ...[Details]
-
Linear Technology Corporation introduces the LT3048 , a step-up DC/DC converter with an integrated LDO output that provides a low noise, low ripple 15V bias supply . The LT3048-15 provid...[Details]
-
According to foreign media reports on December 14, after TSMC started construction of its US$12 billion Arizona factory, Samsung Electronics also announced that it will build a new semiconductor fact...[Details]
-
POE (Power Over Ethernet) is also known as a LAN-based power supply system or Active Ethernet, and is sometimes referred to as Power over Ethernet. This is the latest standard specification for trans...[Details]
-
The use of bimetal thermometers requires calibration to maintain the accuracy of bimetal thermometers in temperature measurement and reduce temperature measurement errors. The calibration method of...[Details]
-
1. Overview of spi
SPI is the abbreviation of Serial Peripheral Interface. It is a synchronous serial interface technology introduced by Motorola. It is a high-speed, full-duplex, synchronous ...[Details]
-
It is reported that Professor Wang Chaoyang's team at Pennsylvania State University in the United States has developed a thermally regulated lithium iron phosphate battery (TMB) that can simultaneous...[Details]
-
1. Pin Description JZ2440 SDRAM wiring diagram You can see that two SDRAMs are connected to the development board in parallel, with a total of 27 address lines and 32 data lines (16 each). (1)...[Details]
-
There are two types of bursting strength testers: hydraulic bursting and pneumatic bursting. The hydraulic pressure acts on the test sample above the rubber tympanic membrane to burst the tested samp...[Details]
-
The content of this article mainly focuses on the connotation, function, scale, perspective and data source of autonomous driving vehicle testing scenarios.
01. Scenario elements and sce...[Details]
51mcu
京公网安备 11010802033920号
EEWORLD
