The properly and electrostatically measured taping materials are used for the components, but attention should be paid to the fact that there is some danger the parts absorb on the top
tapes to cause a failure in the mounting and the parts are destructed by static electricity (more than 1kV : 1J, 2A, 2B, 2E 0.5kV : 1E, Human Body Model 100pF 1.5kΩ) to change the
resistance in the conditions of an excessive dryness or after the parts are given vibration for a long time as they are packaged on the tapes. Similarly, care should be given not to apply the
excessive static electricity when mounting on the boards.
●
Ionic impurities such as flux etc. that are attached to these products or those mounted onto a PCB, negatively affect their moisture resistance, corrosion resistance, etc. The flux may
contain ionic substances like chlorine, acid, etc. while perspiration and saliva include ionic impurities like sodium (Na
＋
), chrorine (Cl
−
) etc. Therefore these kinds of ionic substances may
induce electrical corrosion when they invade into the products. Either thorough washing or using RMA solder and flux are necessary since lead free solder contains ionic substances.
Washing process is needed, before putting on moisture proof material in order to prevent electrical corrosion.
●
Please pay attention that the top of an iron does not direct touch to the components. There is a risk that may cause a change in resistance. Take care that another risk may happen that
the protecting coat is carbonized in an instant when touched directly by the top of the iron, also climatic-proof for electric corrosion or insulation of protecting coat may be dropped down.
Be sure not to give high temperature on the top of the iron as it will degrade the protecting coat.
●
Avoid storing components under direct sun rays, high temperature/humidity. Direct sun rays will cause quality change of taping and difficulty of keeping appropriate peeling strength. 5∼
35℃/35∼75%RH, there is no deterioration of solderability for 12 months, but take special care for storing, because condensation, dust, and toxic gas like hydrogen sulfide, sulfurous acid
gas, hydrogen chloride, etc. may drop solderability.
The signal analyzer uses TI's TMS320VC5509A as the main control unit, uses the high-performance audio codec AIC23B to collect external signals, and uses a TFT LCD screen to display the collected signa...
In recent years, in order to realize the IoT society, it is necessary to install power sources in all objects. However, in the case of difficulty in power wiring and battery replacement, energy harves...
The MIMXRT1020-EVK kit is based on NXP's cost-effective i.MX RT1020 processor, which is based on the ArmCortex-M7 core and can run at a maximum frequency of 528MHz. It supports AES and HAB encryption,...
With the popularity of USB Type-C interface, the fast charging communication protocol based on USB PD is becoming the mainstream in the industry. At the same time, the second largest fast charging pro...
/*Program description: Use timer TA to generate a fixed-cycle square wave, and control the high-level time of the square wave to controlthe average output power. This control method is called PWM modu...
Late last night, there was a thunderclap regarding Lenovo Group’s listing on the Science and Technology Innovation Board: the Shanghai Stock Exchange terminated the review of Lenovo Group’s listing on...
DSP and ARM Processors
京公网安备 11010802033920号
EEWORLD
