5.0 mm x 3.2 mm Package Pinout ............................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Device Configurations and Pin-outs ............................................................................................................................................. 9
Pin-out Top Views................................................................................................................................................................. 9
Test Circuit Diagrams for LVCMOS and Clipped Sinewave Outputs ......................................................................................... 10
Frequency Stability ............................................................................................................................................................. 16
Output Frequency and Format............................................................................................................................................ 16
Output Frequency Tuning ................................................................................................................................................... 16
Pin 1 Configuration (OE, VC, or NC) .................................................................................................................................. 17
Control Voltage Bandwidth ................................................................................................................................................. 20
Pull Range and Average Pull Range .................................................................................................................................. 22
Output Frequency ............................................................................................................................................................... 23
2
I C Control Registers .......................................................................................................................................................... 25
Serial Interface Configuration Description .......................................................................................................................... 28
Serial Signal Format ........................................................................................................................................................... 28
Parallel Signal Format ........................................................................................................................................................ 29
Parallel Data Format ........................................................................................................................................................... 29
2
I C Timing Specification ...................................................................................................................................................... 31
2
I C Device Address Modes ................................................................................................................................................. 32
Schematic Example ............................................................................................................................................................ 33
Dimensions and Patterns ........................................................................................................................................................... 34
Additional Information ................................................................................................................................................................ 36
Revision History ......................................................................................................................................................................... 37
Rev 1.05
Page 3 of 38
www.sitime.com
SiT5156
1 MHz to 60 MHz, ±0.5 to ±2.5 ppm, Elite Platform™ Super-TCXO
Electrical Characteristics
All Min and Max limits are specified over temperature and rated operating voltage with 15 pF output load unless otherwise
stated. Typical values are at 25°C and 3.3V Vdd.
Table 1. Output Characteristics
Parameters
Nominal Output Frequency Range
Operating Temperature Range
Symbol
F_nom
T_use
Min.
1
-20
-40
-40
Frequency Stability over
Temperature
Initial Tolerance
Supply Voltage Sensitivity
F_stab
–
–
–
F_init
F_Vdd
–
–
–
–
Output Load Sensitivity
F_load
–
–
–
Frequency vs. Temperature Slope
ΔF/ΔT
–
–
–
Dynamic Frequency Change during
Temperature Ramp
One-Year Aging
20-Year Aging
F_dynamic
–
–
–
F_1y
F_20y
–
–
Typ.
–
–
–
–
–
–
–
–
±7.10
±11.83
±28.40
±0.81
±1.35
±3.24
±15
±25
±60
±0.13
±0.21
±0.50
±1
±2
Max.
60
+70
+85
+105
±0.5
±1.0
±2.5
±1
±16.25
±32.50
±65.0
±2.75
±5.50
±11.00
±25
±50
±100
±0.21
±0.42
±0.83
–
–
Unit
MHz
°C
°C
°C
ppm
ppm
ppm
ppm
ppb
ppb
ppb
ppb
ppb
ppb
ppb/°C
ppb/°C
ppb/°C
ppb/s
ppb/s
ppb/s
ppm
ppm
Initial frequency at 25°C at 48 hours after 2 reflows
[i=s]This post was last edited by Aguilera on 2020-8-6 08:48[/i]First is the clock module (CS) of msp432. Personally, I think the most distinctive feature of msp432 should be the combination of ultra-...
[i=s]This post was last edited by btty038 on 2019-10-28 16:19[/i]What is the function of the fan-shaped microstrip in the figure?
What is the function of the isolation device in the figure?
Why doesn'...
[i=s]This post was last edited by wenyangzeng on 2019-9-22 11:51[/i]NUCLEO_G431RB Review (3) Oversampling 16-bit ADCOne of the highlights of NUCLEO_G431 is that the ADC conversion bit number reaches 1...
1. Development Background of Tire Pressure Gauge
Air pressure is the lifeblood of a tire. Too high or too low pressure will shorten its service life. Too low pressure will increase the tire contact ar...
[i=s]This post was last edited by 237012013 on 2022-4-21 17:18[/i]The omnidirectional microphone connection cable is an RJ9 (4p4c) interface (should be a supporting device for the conference system). ...
I soldered the hardware yesterday, and there is no problem with the hardware. At first, I used the latest integrated development environment MPLAB X IDE v1.41, XC16 compiler. But I couldn't create a s...[Details]
The novel unpackaged LED has better heat dissipation conditions and integrates epitaxy, die and packaging processes, making it easier to match secondary optical design lighting fixtures… LED li...[Details]
The voltage on C1 in the figure is the voltage after bridge rectification. Rs1 samples the current flowing through the MOS tube and performs cycle-by-cycle current limiting control to prevent the cur...[Details]
Not long ago, iPad2 was launched amid the anticipation of Apple fans around the world, and is expected to continue Apple's legend. And a piece of news not long ago also made the medical field, whic...[Details]
Fuwei Group Silicon Labs low-power MCU C8051F9XX is used in unprovoked medical care solutions. This series of chips has been widely used in RFID tags, water and gas meter measurement, sensor interf...[Details]
Traditional TDR is a commonly used tool for testing PCB, Connector, Cable, Backplance, etc., mainly testing impedance parameters. By using digital signal processing methods such as FFT, S parameters ...[Details]
Many embedded newbies like me probably encounter the same problem when learning touch using mini2440. No matter how I check the register configuration repeatedly with the manual, or type the final co...[Details]
Jiang Xiaotang, senior technical expert of the end intelligence team of Alibaba Taobao Technology Department, introduced MNN's heterogeneous computing solution at the Khronos·VeriSilicon Technology S...[Details]
There are three typical reset circuits:
(1) Connect a 100K ohm pull-up resistor to the RST/NMI pin.
(2) Add a 0.1uf capacitor to (1) and ground one end of the capacitor to make the ...[Details]
According to Xiamen Daily, the first phase of the power lithium battery production line of AVIC Lithium Battery Technology Co., Ltd. will start construction before the end of the year, and the indust...[Details]
Are the tragic Lion Air crash in Indonesia last October, followed by the Ethiopian Airlines crash in mid-March this year, a warning to the automotive industry? indeed so. Although the automation tech...[Details]
"Next year will be the first year for the collaborative implementation of C-V2X, vehicle, road and cloud. However, the implementation of C-V2X must first be solved in stages and scenarios; second,...[Details]
Teledyne Technologies Incorporated and FLIR Systems, Inc jointly announced that they have entered into a definitive agreement for Teledyne to acquire FLIR in a cash and stock transaction valued at ap...[Details]
This paper introduces a method for realizing position sensorless drive of surface mounted permanent magnet synchronous motor (SPMSM) by using 120o trapezoidal wave alternation and estimating the ro...[Details]
Since cars consume large amounts of electricity, only battery technologies with high power density are desirable, and since cars need to be used every day, the batteries must be rechargeable. Howev...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
