S72WS-N Based MCP/PoP Products
1.8 Volt-only x16 Flash Memory and SDRAM on Split Bus
256/512 Mb Simultaneous Read/Write, Burst Mode Flash Memory
512 Mb NAND Flash
1024 Mb NAND Interface ORNAND Flash Memory on Bus 1
512/256/128 Mb (8M/4M/2M x 16-bit x 4 Banks) Mobile SDRAM on
Bus 2
Data Sheet
(Advance Information)
S72WS-N Based MCP/PoP Products Cover Sheet
Notice to Readers:
This document states the current technical specifications regarding the Spansion
product(s) described herein. Each product described herein may be designated as Advance Information,
Preliminary, or Full Production. See
Notice On Data Sheet Designations
for definitions.
Publication Number
S72WS-N_00
Revision
A
Amendment
9
Issue Date
May 8, 2007
Data
Sheet
(Advan ce
Infor m a tio n)
Notice On Data Sheet Designations
Spansion Inc. issues data sheets with Advance Information or Preliminary designations to advise readers of
product information or intended specifications throughout the product life cycle, including development,
qualification, initial production, and full production. In all cases, however, readers are encouraged to verify
that they have the latest information before finalizing their design. The following descriptions of Spansion data
sheet designations are presented here to highlight their presence and definitions.
Advance Information
The Advance Information designation indicates that Spansion Inc. is developing one or more specific
products, but has not committed any design to production. Information presented in a document with this
designation is likely to change, and in some cases, development on the product may discontinue. Spansion
Inc. therefore places the following conditions upon Advance Information content:
“This document contains information on one or more products under development at Spansion Inc.
The information is intended to help you evaluate this product. Do not design in this product without
contacting the factory. Spansion Inc. reserves the right to change or discontinue work on this proposed
product without notice.”
Preliminary
The Preliminary designation indicates that the product development has progressed such that a commitment
to production has taken place. This designation covers several aspects of the product life cycle, including
product qualification, initial production, and the subsequent phases in the manufacturing process that occur
before full production is achieved. Changes to the technical specifications presented in a Preliminary
document should be expected while keeping these aspects of production under consideration. Spansion
places the following conditions upon Preliminary content:
“This document states the current technical specifications regarding the Spansion product(s)
described herein. The Preliminary status of this document indicates that product qualification has been
completed, and that initial production has begun. Due to the phases of the manufacturing process that
require maintaining efficiency and quality, this document may be revised by subsequent versions or
modifications due to changes in technical specifications.”
Combination
Some data sheets contain a combination of products with different designations (Advance Information,
Preliminary, or Full Production). This type of document distinguishes these products and their designations
wherever necessary, typically on the first page, the ordering information page, and pages with the DC
Characteristics table and the AC Erase and Program table (in the table notes). The disclaimer on the first
page refers the reader to the notice on this page.
Full Production (No Designation on Document)
When a product has been in production for a period of time such that no changes or only nominal changes
are expected, the Preliminary designation is removed from the data sheet. Nominal changes may include
those affecting the number of ordering part numbers available, such as the addition or deletion of a speed
option, temperature range, package type, or V
IO
range. Changes may also include those needed to clarify a
description or to correct a typographical error or incorrect specification. Spansion Inc. applies the following
conditions to documents in this category:
“This document states the current technical specifications regarding the Spansion product(s)
described herein. Spansion Inc. deems the products to have been in sufficient production volume such
that subsequent versions of this document are not expected to change. However, typographical or
specification corrections, or modifications to the valid combinations offered may occur.”
Questions regarding these document designations may be directed to your local sales office.
2
S72WS-N Based MCP/PoP Products
S72WS-N_00_A9 May 8, 2007
S72WS-N Based MCP/PoP Products
1.8 Volt-only x16 Flash Memory and SDRAM on Split Bus
256/512 Mb Simultaneous Read/Write, Burst Mode Flash Memory
512 Mb NAND Flash
1024 Mb NAND Interface ORNAND Flash Memory on Bus 1
512/256/128 Mb (8M/4M/2M x 16-bit x 4 Banks) Mobile SDRAM on
Bus 2
Data Sheet
(Advance Information)
Features
Power supply voltage of 1.7 to 1.95V
High Performance
Flash access time: 80 ns for NOR Flash, 25 ns for ORNAND
Flash
Flash burst frequencies: 54 MHz, 66MHz, 80MHz
Mobile SDRAM burst frequency: 104 MHz, 133 MHz (DDR)
Package:
– 9.0 x 12.0 mm MCP BGA
– 11.0 x 13.0 mm MCP BGA
– 15.0 x 15.0 x 1.2 mm MCP Package-on-Package (PoP)
Operating Temperature
– –25°C to +85°C (wireless)
General Description
The S72WS series is a product line of stacked Multi-Chip Product (MCP) packages and consists of:
One or two NOR flash memory dies
One NAND Interface ORNAND die
Separate bus for one or more Mobile SDRAM die
The products covered by this document are listed in the table below.
Device
S72WS256ND0
S72WS256NDE
S72WS256NEE
S72WS512NFG
S72WS512NEG
S72WS512NEF
S72WS512NFF
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
NOR Flash Density
512Mb
256Mb
X
128Mb
NAND Flash Density
1024Mb
512Mb
512Mb
SDRAM Density
256Mb
128Mb
X
X
Note
For a list of PoP OPNs, please contact the local sales representative or refer to the valid combinations tables.
For detailed specifications, please refer to the individual data sheets.
Document
S29WS256N
S30MS01GP/512P
128 Mb Mobile SDRAM Type 1
128 Mb Mobile SDRAM Type 2
128 Mb Mobile DDR-DRAM Type 5
256 Mb Mobile SDRAM Type 2
512 Mb Mobile DDR-DRAM Type 1
512 Mb Mobile SDRAM Type 4
512 Mb NAND Type 1
512 Mb Mobile DDR-DRAM Type 5
512 Mb Mobile DDR-DRAM Type 2
Publication Identification Number (PID)
S29WS-N_00
S30MS-P_00
SDRAM_01
SDRAM_05
SDRAM_07
SDRAM_05
SDRAM_09
SDRAM_06
NAND_01
DRAM_04
DRAM_05
Publication Number
S72WS-N_00
Revision
A
Amendment
9
Issue Date
May 8, 2007
This document contains information on one or more products under development at Spansion Inc. The information is intended to help you evaluate this product. Do not design in
this product without contacting the factory. Spansion Inc. reserves the right to change or discontinue work on this proposed product without notice.
Data
Sheet
(Advan ce
Infor m a tio n)
Table of Contents
Features
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
General Description
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
1.
Product Selector Guide
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
1.1
NOR Flash + DRAM Products . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
1.2
NOR Flash + ORNAND Flash + DRAM Products . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
MCP Block Diagram
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
2.1
NOR Flash + ORNAND Flash + DRAM Products . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Connection Diagram
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
3.1
2 x 256Mb NOR Flash with 256Mb SDRAM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
3.2
2 x 256Mb NOR Flash with 128Mb SDRAM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
3.3
256Mb NOR Flash with 128Mb SDR/DDR-DRAM. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
3.4
512 Mb NOR Flash with 1024-Mb ORNAND on Bus 1 and 512 or 256-Mb SDRAM
on Bus 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
3.5
512Mb NOR Flash with 1024-Mb ORNAND on Bus 1 and 512 or 256 Mb SDRAM on Bus 2 12
3.6
512Mb NOR Flash with 512-Mb NAND on Bus 1 and 512-Mb SDRAM on Bus 2. . . . . . . . . 13
3.7
Lookahead Diagram on Split Bus . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
3.8
NOR Flash and DRAM Input/Output Descriptions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Ordering Information
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
4.1
Valid Combinations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Physical Dimensions
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Revision History
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
2.
3.
4.
5.
6.
4
S72WS-N Based MCP/PoP Products
S72WS-N_00_A9 May 8, 2007
D at a
S hee t
(Adva nce
In for m ation)
1. Product Selector Guide
1.1
NOR Flash + DRAM Products
Device-Model#
S72WS256ND0BAWB7
256 Mb
S72WS256ND0BAWBB
S72WS256NDEBAWU7
128
S72WS256NDEBAWUB
256 Mb
S72WS256NEEBAWU7
256
S72WS256NEEBAWUB
S72WS256ND0BFWB7
256 Mb
S72WS256ND0BFWBB
S72WS256NDEBFWU7
128
S72WS256NDEBFWUB
256 Mb
S72WS256NEEBFWU7
256
S72WS256NEEBFWUB
S72WS256ND0KFWD3
256 Mb
S72WS256ND0BFW93
66 MHz
128
133 MHz
(DDR)
133 MHz
(DDR)
5
sector
unprotected
9x12x1.2
2
sector
unprotected
15x15x1.25
256 Mb
54 MHz
104 MHz
1
2
sector
unprotected
9x12x1.4
—
54 MHz
128
104 MHz
2
1
2
1
sector
unprotected
9x12x1.2
256 Mb
54 MHz
104 MHz
1
2
sector
unprotected
9x12x1.4
—
54 MHz
128
104 MHz
2
1
Flash
Density
(Code)
Flash
Density
(Data)
Burst
Speed
(MHz)
SDRAM
Density
SDRAM burst
Speed (MHz)
DRAM
Supplier
1
DYB
sector
unprotected
Package
9x12x1.2
May 8, 2007 S72WS-N_00_A9
S72WS-N Based MCP/PoP Products
5
京公网安备 11010802033920号
EEWORLD
