As shown in the figure, both BUCKs are used to obtain a negative pressure output.
The output voltage and ground at the output end are swapped.But the circuit below also connects the negative voltage o...
[i=s]This post was last edited by Simulation Chain Newbie on 2022-11-15 19:52[/i]When amplifying a 500mVpp, 100Mhz square wave signal using opa843 simulation, the resistor shown in Figure 1 can be amp...
Reprinted from: https://www.toutiao.com/article/71491300338386048341] Introduction
Let me start with a little off-topic talk...
After I entered graduate school, my supervisor forced me to learn about ...
Are the sampling frequency and sampling rate of the microcontroller ADC the same concept? The sampling frequency and rate must be much greater than the frequency and rate of the sampled signal?...
Use stm32f429's SPI5 to connect to W5500 and call the SPI5's DMA channel
Set as server and PC as client.
The program uses the officially downloaded driver, which has been modified to support DMA.
In t...