Hello everyone, I am an automotive electronics hardware engineer.
When selecting a power SBC, you should pay attention to the battery voltage range and then combine it with the test standards to selec...
It may surprise you to learn that a technology that has been around for nearly two decades has paved the way for connected cars. ECall is old fashioned by high-tech standards, but it is now mandatory ...
USB-C, DFP, 5V/3A output, 85-265VAC input, adapter, low cost reference designThe UCC28700 and TPS25810 are used to provide isolated 5 V at 3 A over the USB type C interface. The UCC28700 performs prim...
introduction
Built-in test (BIT) is a new technical concept proposed by the United States in the field of military testing in the 1970s. Its purpose is to improve the maintainability, testabil...[Details]
DYNA4 provides a variety of complex simulation models for passenger cars and commercial vehicles, including vehicle dynamics models, engine models, powertrain models, motor models, ADAS sensors and...[Details]
Recently, the Nanjing Municipal People's Government issued the Nanjing Major Economic and Social Development Project Plan for 2022. There are 420 major projects in Nanjing in 2022, with a planned to...[Details]
challenge:
In order to perform an on-site acquisition and analysis of physical quantities, such as pressure and forces generated by railway switches during operation and/or train passage, we c...[Details]
Biosensors
are instruments that are sensitive to biological substances and convert their concentrations into electrical signals for detection.
Biosensors
have the functions of receivers ...[Details]
1. External interrupt 0, 1; caused by the level signal of pin /INT0, /INT1 respectively. 2. Timer/Counter 0, 1; caused by the overflow of T0, T1 respectively. 3. Serial port sending, receiving; c...[Details]
Recently, a company developed and produced LED bulbs (LED bulbs). As a reference, there are several international brands of LED bulbs on hand, including Philips, Panasonic, Toshiba, Sharp, Lemnis P...[Details]
With the development of IT technology, multimedia teaching has been widely used in schools. However, traditional multimedia teaching has shortcomings such as weak interactivity, which is not conduc...[Details]
introduction
Reset is the initialization operation of the microcontroller. Its function is to put the microcontroller and other components in the system into a certain initial state and star...[Details]
One of the key technologies of new energy vehicles is the power battery. The quality of the battery determines the cost of electric vehicles on the one hand, and the driving range of electric vehic...[Details]
The inverter has many setting parameters, and each parameter has a certain selection range. During use, it is often encountered that the inverter cannot work normally due to improper setting of ind...[Details]
During the Beijing Auto Show in April, we met Jack Weast, Intel Fellow, Vice President of Intel Corporation, and General Manager of the Automotive Division. He revealed Intel Automotive's China pla...[Details]
Decision of the State Council on Temporarily Adjusting the Provisions of Relevant Administrative Regulations, State Council Documents and Departmental Regulations Approved by the State Council in P...[Details]
The Cirrus CS485xx DSP family provides high-performance post-processing and mixing of digital audio. Dual clock domains provided on the PCM input allow mixing of audio streams with different sampli...[Details]
On November 4, the Henan Provincial Development and Reform Commission issued the "Notice on the Implementation of the Fourth Batch of Source-Grid-Load-Storage Integration Projects" and the "Notice ...[Details]