1. When using a module, we need to initialize it accordingly and set the functions we are going to use.
Divided into three parts----
1) Mailbox initialization configuration: First, you should determin...
Using timer interrupt to realize variable frequency flashing of LED lightsThe example is relatively simple, and the source code is directly posted.
#include "DSP2833x_Device.h" // DSP2833x Headerfile ...
Using STM32F103VET6 microcontroller, DAC+DMA+TIM2 trigger mode, channel 1 outputs sine wave, refer to the routine configuration, but there is no signal output, the hardware is checked and it is normal...
[i=s]This post was last edited by yjtyjt on 2019-9-17 20:36[/i]Showing off the Jingdong E-card exchanged with E-coins. I liked some of the coins and exchanged them for a 400 yuan E-card on Jingdong. W...
[i=s]This post was last edited by elec32156 on 2020-4-19 16:33[/i]The figure shows 74HC165 shift registers, which are connected in series. One is 8 bits, and two can achieve 16-bit data output (ultima...
[i=s]This post was last edited by elec32156 on 2020-2-18 10:54[/i]As shown in the following PMOS switch circuit, there are some unclear points during the switching process:
1) After the transistor is ...