1. Contact factory for improved stabilities or additional product options. Not all options and codes are available at all
frequencies.
2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency
control voltage, load, temperature (25°C).
3. Phase noise degrades with increasing output frequency.
4. Subject to technical modi cation.
5. Contact factory for availability.
For Additional Information, Please Contact
USA:
Vectron International
267 Lowell Road
Hudson, NH 03051
Tel: 1.888.328.7661
Fax: 1.888.329.8328
Europe:
Vectron International
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 3328.4784.17
Fax: +49 (0) 3328.4784.30
Asia:
Vectron International
1F-2F, No 8 Workshop, No 308 Fenju Road
WaiGaoQiao Free Trade Zone
Pudong, Shanghai, China 200131
Tel: 86.21.5048.0777
Fax: 86.21.5048.1881
Disclaimer
Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
According to the circuit diagram in the manual of XL6019, C13 will get very hot after power is turned on. XL6019 outputs 1.8v, and the voltage measured at the input terminal is 3.3v. I have checked an...
[i=s]This post was last edited by littleshrimp on 2019-5-11 19:55[/i] I remember that it was exposed before that the official website of a certain country's embassy was crowded with advertisements. Th...
Electronic door guardAuthor: cruelfoxI. Introduction of the Work Title: Electronic Door Guard. The idea is to use RSL10 with a low-power accelerometer, attached to the back of the door panel, to coll...
cruelfoxonsemi and Avnet IoT Innovation Design Competition