The JDSU near infrared fused coupler splits or combines light at any selected
wavelength from 700 to 1150 nm. Designed for applications in fiber laser, sensor
and avionics applications, the coupler utilizes low loss fused fiber technology. No
light leaves the fiber and therefore no alignment is required; and there are no
unwanted reflections. Furthermore the output fiber pigtails may be directly
integrated into beam delivery systems.
NORTH AMERICA
:
800 498-JDSU (5378)
WORLDWIDE
:
+800 5378-JDSU
WEBSITE
:
www.jdsu.com
FUSED COUPLER, NEAR INFRARED
2
Configuration
1x2
P1 (Red) COMMON (Input)
P2 (Blue) SIGNAL (Input)
P3 (Red) TAP (Output)
2x2
P1 (Red) COMMON (Input)
P2 (Blue) SIGNAL (Input)
P4 (Blue)
P3 (Red) TAP (Output)
Insertion Loss
Coupling Ratio
Grade
Available Housing Option
Signal Path Insertion Loss
1, 2
(Maximum)
0.9 dB
1.1 dB
1.5 dB
1.7 dB
2.2 dB
2.4 dB
3.0 dB
3.2 dB
3.8 dB
4.0 dB
Tap Path Insertion Loss
1, 2
(Maximum)
12.2 dB
12.4 dB
8.4 dB
8.6 dB
6.4 dB
6.5 dB
4.9 dB
5.1 dB
3.8 dB
4.0 dB
10%
10%
20%
20%
30%
30%
40%
40%
50%
50%
A
B
A
B
A
B
A
B
A
B
3, 4, 5, 6
3, 4, 5, 6
3, 4, 5, 6
3, 4, 5, 6
3, 4, 5, 6
3, 4, 5, 6
3, 4, 5, 6
3, 4, 5, 6
3, 4, 5, 6
3, 4, 5, 6
1. Insertion loss at operating wavelength range (not including PDL, TDL or connector losses).
2. In 2x2 couplers with a coupling ratio of 20% or lower, insertion loss is not specified for launch through second input port (P4).
FUSED COUPLER, NEAR INFRARED
3
Housing Option
Housing Code
3
4
5
6
Description
Regular
Ø 0.9 mm slim
Ø 0.9 mm semi-ruggedized
Ø 3.0 mm fully ruggedized
1x2, 2x2 Dimensions (mm)
3.0 (Ø) x 50 (L)
3.0 (Ø) x 60 (L)
5.0 (Ø) x 75 (L)
80 (L) x 10 (W) x 8 (H)
Pigtail
Primary-coated fiber
Ø 0.9 mm loose-tube
Ø 0.9 mm loose-tube
Ø 3.0 mm fan-out sleeving
Specifications
Parameter
Operating wavelength range
1
Excess loss
Return loss/Directivity
Pigtail tensile load
Optical power handling
Operating temperature range
2
Storage temperature range
Fiber type
Grade A
Grade B
Typical
Minimum
Maximum
Maximum
Any wavelength within the 700 to 1150 nm range
0.30 dB
0.50 dB
50 dB
5N
4W
-40 to 75 °C
-40 to 85 °C
Speciality fiber
1. Any specific wavelength point from within the range 633 to 850 nm may be selected. For wavelengths outside of this range, contact JDSU with specific requirements.
2. For connectorised component, operating temperature range is -5 to 75 °C.
FUSED COUPLER, NEAR INFRARED
4
Ordering Information
For more information on this or other products and their availability, please contact your local JDSU account manager or
JDSU directly at 1-800-498-JDSU (5378) in North America and +800-5378-JDSU worldwide or via e-mail at
customer.service@jdsu.com.
Sample: FFS-060K31A10 (Fused Fiber Speciality Coupler, 1060 nm, 50/50 coupling ratio, regular housing, 1x2, A grade, 1 m
pigtails, no connectors)
FFS-
Code
7
8
9
0
1
Wavelength
(First Digit)
7xx nm
8xx nm
9xx nm
10xx nm
11xx nm
Code
A
C
E
H
K
Coupling Ratio
1
10%
20%
30%
40%
50%
Code
1
2
Configuration
1x2
2x2
Code
0
1
3
5
9
A
B
Connectors
2, 4
None
FC/PC
FC/APC
SC/APC
FC/UPC
SC/UPC
LC
5
Code
A
B
Grade
Grade A
Grade B
Code
Wavelength
(Second and
Third Digit)
Examples:
33
x33 nm
32
x32 nm
57
x57 nm
Code
3
4
5
6
Housing
2
Regular
Ø 0.9 mm slim
Ø 0.9 mm
semi-ruggedised
Ø 3.0mm fully
ruggedised
Code
0
1
Pigtail Length
3
(Minimum)
0.5 meter
1 meter
1. Other coupling ratio are available. Please contact JDSU for ordering codes of coupling ratios not listed.
2. Connectors may be fitted to housing types 4, 5 and 6. For connectorisation of housing type 3, please contact JDSU sales office.
3. Minimum pigtail length. Other pigtail lengths are available on request. When the pigtail has been modified to include a
connector, pigtail length measurment includes the connector end face.
4. Excess Loss in specification table does not include connector losses.
5. LC connector is not available for housing code 6, fully ruggedised housing.
LC is a registered trademark of Lucent Technologies.
Today is Chinese Valentine's Day, I wish you all a happy holiday!
I just went to Alipay to get a certificate and got a partner. Has everyone received it? ? ?...
[size=4][color=#000000]TI MSP430 series microcontroller, the baud rate value of the usart module is determined by the following three registers: UxBR0, UxBR1, UxMCTL [/color][/size] [size=4][color=#00...
[i=s]This post was last edited by General-P on 2022-8-24 22:36[/i]The MCU generates an event and sends a command to the Bluetooth APP
1. IntroductionEarlier, we tested the Bluetooth sending command to...
To answer this question, before discussing power, we must first talk about how far the communication distance between the two is. When we take out our mobile phones, theoretically we can talk to anoth...
[i=s]This post was last edited by a newbie on 2019-7-11 01:15[/i]System introduction: With CH549 board as the main control, a remote control system is made, which receives commands and sends data from...
[i=s]This post was last edited by qwqwqw2088 on 2020-8-11 09:12[/i]The BQ40Z80 is a 2-cell to 7-cell battery pack manager from TI that uses Impedance Track fuel-gauging technology.
Fault phenomenon: T...
I've been using the STM8S003 chip to do a project recently. When doing serial communication, I found that the protocol I wrote before was too simple and not suitable for the project. //Protocol: 0X...[Details]
After more than 20 companies announced their cancellation of their participation in the WMC exhibition, GSMA was forced to announce the cancellation of MWC 2020, the first time in 33 years. As a ...[Details]
A single-chip microcomputer is made by integrating CPU, ROM, RAM, TIMER/COUNTER and input/output interface (I/O) on a large-scale integrated circuit chip. Some single-chip microcomputers also integrat...[Details]
Panel prices are already generally below cash costs, and manufacturers' losses are mounting. Since 2017, the prices of display panel products have been falling. Industry insiders believe that the d...[Details]
The combination of robots and the Internet has always been favored by everyone. In the medical field, the application of intelligent machines is common. However, behind this prosperity, what is more...[Details]
introduction Air suspension mainly includes passive suspension and controllable electronic suspension. Passive suspension can suppress and reduce the dynamic load and vibration of the vehicle...[Details]
1. Hardware Solution The "Attendance Management System" is an attendance management system suitable for enterprises or schools that uses RFID radio frequency cards as information identification carri...[Details]
//Description: My board is mini2440 with 2M s29al016j nor flash and a 256M k9f2608u0b nand flash. //This article is not entirely original, it is just a modification of the post by netizen "sblpp" at ...[Details]
0 Introduction
Traditional human-computer interaction relies on complex keyboards or buttons. With the development of science and technology, some new human-computer interaction methods have been b...[Details]
Adaptive tactile technology is increasingly being used in the automotive industry. Merritt's adaptive tactile multi-function knob is one of the projects that follows this trend. Every day we push b...[Details]
Single-chip microcomputers are widely used in various fields, and there are many kinds of button designs for human-computer communication. Different design methods have different advantages and disad...[Details]
The two-year-long patent dispute between Apple and Qualcomm has finally come to a conclusion. According to Reuters, the Qualcomm-Apple patent dispute case opened in the San Diego federal court ...[Details]
Recently, according to information from the Chongqing Property Rights Exchange Network, 17% of the equity of Chongqing HKC Jinyu Optoelectronics Technology Co., Ltd. (hereinafter referred to as Chong...[Details]
A program consists of a code segment, a read-only data segment, a data segment, a bss segment, etc. The program can be burned on Nor Flash at the beginning, and the code segment can still run on No...[Details]
The principle of solar cells: Sunlight shines on the semiconductor pn junction, forming new hole-electron pairs. Under the action of the pn junction electric field, holes flow from the n region to ...[Details]