78299-246LF

In 1953, the first magnetically guided AGV was invented. This is done by burying magnetic bars underground or sticking magnetic strips on the ground to achieve positioning and navigation through ...[Details]

Now , most of the COB packaging of LEDs , including the Japanese COB packaging technology, are based on the packaging of the inner substrate, which is to integrate N chips together on the inner s...[Details]

Part 6: Conditional States and Branching We have already touched upon conditional states when we were discussing CPSR. We control the flow of execution at run time by jumping (branching) or by instru...[Details]

German chip giant Infineon Technologies is urging automakers to rethink their "just-in-time" supply chain strategies as they need to start building up semiconductor inventories as a global shortage o...[Details]

As electronic devices become more powerful and support more and more network frequency bands, RF front-end modules have become an indispensable part of them. In the RF front-end, filters are one of t...[Details]

Introduction For most flash-based embedded systems, an important requirement is the ability to update the firmware after these systems are installed on the terminal product. This capability is calle...[Details]

This paper introduces a design of a programmable audio instrument test signal source based on DDFS (direct frequency synthesis) technology. The system uses a single-chip microcomputer as a controller...[Details]

Synopsys, a member of the TSMC (2330) Alliance, announced yesterday (2) that it will assist TSMC in expanding its 5nm process to accelerate product development. It will use TSMC's 5nm process technol...[Details]

    Abstract: This article introduces the functional characteristics and working principle of the multi-channel 12-bit serial A/D converter TLV2544/2548 produced by TI. Combined with development exa...[Details]

High performance infrared remote control switch circuit The transmitter uses 555 connected as a multivibrator, the oscillator frequency is 35KHZ, driving the infrared transmittin...[Details]

To control brightness, light emitting diodes (LEDs) require a constant current. This is achieved by placing a resistor in series with a group of LEDs. Since both the voltage across a group of LEDs an...[Details]

With the continuous advancement of intelligent driving technology, many cars with autonomous driving assistance as their selling point have appeared on the market. Of course, although car companies...[Details]

Recently, Sunlord Electronics stated in an institutional survey that the company's one-piece molded inductors can now be formally mass-produced. The company's one-piece molded inductors can be widely...[Details]

It was originally expected that the US-China trade war would temporarily ease after the G20 meeting in late June, allowing the semiconductor industry to resume the peak season effect that was suppose...[Details]

There are many versions of the "small three electrics" of new energy vehicles. However, the most recognized version is the "small three electrics" consisting of the on-board charger OBC, the on-boa...[Details]