Resistors
Precision High-Voltage
Thick Film
High-Voltage
Precision
Resistors
CGH Series
Thick Film Resistors
1/4 watt to 5 watt
TCR of ±50 or ±100 ppm/°C
100K ohm
CGH Series
to 2000 megohm range
±0.5%, ±1%, ±2% or ±5% tolerance
•
1/4 watt to 5 watt
•
TCR of ±50 or ±100 ppm/°C
•
100K ohm to 2000 megohm range
•
±0.5%, ±1%, ±2% or ±5% tolerance
High thermal
conductivity substrate
High thermal
conductivity substrate
All Pb-free parts comply with EU Directive 2011/65/EU (RoHS2)
Electrical Data
IRC Type
CGH - 1/4
CGH - 1/2
CGH - 1
CGH - 2
CGH - 3
CGH - 5
Power Rating
at 70°C (watts)¹
1/4
1/2
1
2
3
5
Voltage Rating
(volts)²
750
1,500
3,000
5,000
10,000
20,000
Resistance
Range (ohms)³
100K - 100M
100K - 500M
50K - 750M
100K - 1500M
200K - 2000M
300K - 2000M
.5, 1, 2, 5
50, 100
0 - -5
Tolerance
(±%)
4
Maximum TCR
(±ppm/°C)
4
VCR (ppm/V)
5
Notes:
1. For power rating above 70°C, see derating curve.
2. Voltage rating shown is the rated DC continuous working voltage or the sine-wave RMS absolute maximum voltage at commercial line fre-
quency. For DC applications the absolute maximum permissible voltage is 1.5 times the value shown for low repetition short-time-overload or
pulse conditions of 10 seconds or less duration.
3. Contact factory for higher resistance values.
4. For CGH-1 and 2 above 500 meg and CGH-3 and 5 above 1000M only 2 and 5% tolerance and 100 ppm/°C TCR available.
5. Typical voltage coefficient of resistance is -1 to -2 ppm/V measured at fulll rated voltage and 10% rated voltage.
Power Derating Curve
100
90
80
70
60
50
40
30
20
10
0
80
100
120
140
160
180
Temperature Rise Chart
100
90
CGH 1/4
CGH 2-3
CGH 1/2
CGH 5
CGH 1
% of Rated Power
% of Rated Power
80
70
60
50
40
30
20
10
0
0
10
20
30
40
50
60
70
80
90
Ambient Temperature (°C)
IRC reserves the right make changes in
specification without notice or liability.
General Note
to to IRC’s own data productconsidered accurate at time of going to print.
All information is subject
and is
Telephone:
361 992 7900 •
Facsimile:
361 992 3377 •
Website: www.irctt.com
Temperature Rise (°C)
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
Wire and Film Technologies Division
•
data and is considered accurate at time of going
All information is subject to TT Electronics’ own
4222 South Staples Street • Corpus
Christi Texas
78411 USA
to print.
BI Technologies IRC Welwyn
A subsidiary of
TT electronics plc
CGH Series
Issue June
2009 Sheet 1 of 3
http://www.ttelectronics.com/resistors
© TT Electronics plc
12.16
Precision High-Voltage
Thick Film Resistors
Precision High-Voltage
Thick Film Resistors
CGH Series
Environmental Data
Test Condition¹
Maximum
∆R
(±3σ)
Typical²
∆R
Temperature Shock
Short-Time Overload (1.5 times rated V for 10 sec)
Solder Effect
Terminal Strength
Moisture Resistance (no load or polar)
Load Life (1000 hours at 70°C)
Shelf Life (1 year at 25°C)
High-Temperature Exposure (150°C for 2000 hours)
(175°C for 2000 hours)
Dielectric Breakdown³ (1/4 and 1/2 watt size)
(1 watt through 5 watt size)
Dielectric Strength
4
Insulation Resistance at 500 VDC
±0.25%
±0.20%
±0.15%
±0.20%
±0.50%
±1.00%
±0.10%
±0.75%
±1.0%
±0.10%
±0.10%
±0.05%
±0.05%
±0.20%
±0.25%
±0.03%
±0.30%
±0.40%
2000 VDC, 1500 VAC
3500 VDC, 2500 VAC
±0.15%
10
9
ohms typ.
±0.05%
10
11
ohms typ.
Notes:
1. Test method per MIL-STD-202 unless otherwise indicated.
2. Typical defined as that percent change which will include a minimum of 50% of the measured changes in resistance from a variety of lots
representing various unit sizes and ranges.
3. Values shown are the maximum safe dielectric voltage applied from a V block or foil wrapping which extends the complete body length of the
resistor under test.
4. Percent change after the maximum safe dielectric voltage is applied for 1 minute.
Wire and Film Technologies Division
• 4222 South Staples Street • Corpus Christi
Texas
78411 USA
Telephone:
361 992 7900 •
Facsimile:
361 992 3377 •
Website:
www.irctt.com
CGH Series Issue
June
2009 Sheet 2 of 3
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
BI Technologies IRC Welwyn
http://www.ttelectronics.com/resistors
© TT Electronics plc
12.16
Precision High-Voltage
Thick Film Resistors
Physical Data
Physical Data
Precision High-Voltage
Thick Film Resistors
CGH Series
Precision High-Voltage
Thick Film Resistors
1.50 ± 0.125
(38.1 ± 3.2)
BL
1.50 ± 0.125
(38.1 ± 3.2)
BL
0.032 (0.81) DIA.
*
BD
CL
* CGH 1/4 leads are
0.025 (0.64) in diameter”
Dimensions (Inches and (mm))
BD
0.032 (0.81) DIA.
IRC Type
CGH - 1/4
CGH -IRC Type
1/2
CGH - 1/4
CGH - 1
CGH - 1/2
CGH - 2
CGH - 1
CGH - 3
CGH - 2
CGH - 5
CGH - 3
Body Length - BL
Body Diameter - BD
CL
Clean Lead to Clean Lead - CL
0.400 (10.16)
Clean Lead to Clean Lead - CL
0.525 (13.34)
0.400 (10.16)
0.900 (22.86)
0.525 (13.34)
1.250 (31.75)
0.900 (22.86)
2.250 (57.15)
1.250 (31.75)
3.250 (82.55)
2.250 (57.15)
3.250 (82.55)
0.275 ± 0.031 (6.98
Dimensions (Inches and (mm))
± 0.25)
± 0.79)
0.088 ± 0.010 (2.22
Body Length -
±
0.400 ± 0.031 (10.16
BL
0.79)
0.275 ± 0.031 (6.98 ± 1.57)
0.690 ± 0.062 (17.53± 0.79)
0.400 ± 0.031 (10.16 ± 0.79)
1.062 ± 0.062 (26.97 ± 1.57)
0.690 ± 0.062 (17.53 ± 1.57)
2.062 ± 0.062 (52.37 ± 1.57)
1.062 ± 0.062 (26.97 ± 1.57)
3.062 ± 0.062 (77.77 ± 1.57)
2.062 ± 0.062 (52.37 ± 1.57)
Body Diameter BD
0.138 ± 0.016 (3.51
-
± 0.41)
0.088 ± 0.010 (2.22 ± 0.25)
0.297 ± 0.031 (7.54 ± 0.79)
0.138 ± 0.016 (3.51 ± 0.41)
0.297 ± 0.031 (7.54 ± 0.79)
0.297 ± 0.031 (7.54 ± 0.79)
0.297 ± 0.031 (7.54 ± 0.79)
0.297 ± 0.031 (7.54 ± 0.79)
0.297 ± 0.031 (7.54 ± 0.79)
0.297 ± 0.031 (7.54 ± 0.79)
0.297 ± 0.031 (7.54 ± 0.79)
CGH - 5
Ordering Data
3.062 ± 0.062 (77.77 ± 1.57)
Sample Part No.
CGH 3 - 100 - 2205 - F - LF
Ordering Data
IRC Type
Temperature Coefficient
Sample Part
±50 ppm/°C)
(±100 ppm/°C,
No.
Resistance
IRC Type
CGH 1/4, CGH 1/2, CGH 1, CGH 2, CGH 3, CGH 5
CGH 3 - 100 - 2205 - F - LF
CGH 1/4, CGH 1/2, CGH 1, CGH 2, CGH 3, CGH 5
Tolerance
D = ±0.5%
Temperature Coefficient
F = ±1%
(±100 ppm/°C, ±50 ppm/°C)
G = ±2%
J = ±5%
Resistance
RoHS Indicator
Tolerance
LF indicates RoHS compliance
D = ±0.5%
Omit this code for SnPb finish
F = ±1%
G = ±2%
J = ±5%
RoHS Indicator
LF indicates RoHS compliance
Omit this code for SnPb finish
Wire and Film Technologies Division
• 4222 South Staples Street • Corpus Christi
Texas
78411 USA
Telephone:
361 992 7900 •
Facsimile:
361 992 3377 •
Website:
www.irctt.com
CGH Series Issue
June
2009 Sheet 3 of 3
Wire and Film Technologies Division
• 4222 South Staples Street • Corpus Christi
Texas
78411 USA
General Note
Telephone:
361 992 7900 •
Facsimile:
361 992 3377 •
Website:
www.irctt.com
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
CGH
BI Technologies
Series Issue
June
Welwyn
IRC
2009 Sheet 3 of 3
http://www.ttelectronics.com/resistors
© TT Electronics plc
12.16
PCB Design
京公网安备 11010802033920号
EEWORLD
