HDU60-B-20 datasheet, PDF - EEWORLD Datasheet

HDU60-B-20: DescriptionDC-DC CONVERTER 19 COMPATIBLE EUROCARD MULTIPLEV OUTPUT 45-100 WATTS SWITCHING MODE POWER SUPPLIES HDU45, HDU60 AND HDU100 SERIES; File Size354KB，4 Pages; ManufacturerTotal Power International; Websitehttp://www.total-power.com/

Download Datasheet View All

HDU60-B-20 Overview

DC-DC CONVERTER 19 COMPATIBLE EUROCARD MULTIPLEV OUTPUT 45-100 WATTS SWITCHING MODE POWER SUPPLIES HDU45, HDU60 AND HDU100 SERIES

Preview

Download Datasheet

View All

DC-DC CONVERTER 19" COMPATIBLE EUROCARD MULTIPLE

OUTPUT 45-100 WATTS SWITCHING MODE POWER SUPPLIES

HDU45, HDU60 & HDU100 SERIES

FEATURES:

12/24/48VDC INPUT RANGE

19" COMPATIBLE EUROCARD FORMAT

EMI MEET CISPR PUB. 22 & FCC CLASS B

MEET THE SAFETY STANDARDS

CE MARKING COMPLIANCE

HDU45 3UX6HPX160MM VMEbus STANDARD

HDU60 3UX8HPX160MM VMEbus STANDARD

HDU100 3UX10HPX160MM VMEbus STANDARD

SPECIFICATION

INPUT SPECIFICATION

Input Voltage:

Three ranges option.

A Range: 9-18Vdc nominal 12Vdc.

B Range: 18-36Vdc nominal 24Vdc.

C Range: 36-72Vdc nominal 48Vdc.

Input Connector:

DIN 41612 at rear.

Input Current:

HDU45-A: 8.0A,HDU45-B: 4.0A,HDU45-C: 2.5A.

HDU60-A: 10.0A,HDU60-B: 5.0A,HDU60-C: 3.15A.

HDU100-A: 15.0A,HDU100-B: 6.3A,HDU100-C: 4.0A.

Dielectric Withstand:

Meet IEC950.

EMI:

Meet CISPR PUB. 22 & FCC Class B.

Power Fail Signal:

Installed.

Remote (Logic) Inhibit:

Installed.

Overload Protection (OLP):

Fully protected against

output overload and short circuit.

Consult the factory for OLP setting.

OUTPUT SPECIFICATION

Output Voltage:

See Ratings Chart.

Output Current:

See Ratings Chart.

Output Wattage:

Typ. 45 Watts for HDU45.

Typ. 60 Watts for HDU60.

Typ. 100 Watts for HDU100.

Output Connector:

DIN 41612 at rear.

Line Regulation:

Typ. 0.4%.

Load Regulation:

Main VO1 typ. ±1.0%.

Aux. VO2 typ. ±2-3.0%(PR).

± 2.0%(Mag. Amp.)

Aux. VO3 typ. ±2-3.0% (PR).

Aux. VO4 typ. ±2-3.0%(PR).

Noise & Ripple:

Typ. 1% peak to peak.

OVP:

Built-in at main VO1 (latch).

Adjustability:

Available at main output VO1 and

Aux. Output VO2 (Mag. Amp.).

Remote Sense:

Available at HDU60 & 100 single O/P.

Operating Temperature:

0 to +50°C at full load. Derates

linearly to +70°C at half load.

Storage Temperature:

-20 to +85°C.

Temperature Coefficient:

Typ. 0.04% /°C.

Cooling:

Free air convection.

Construction:

6,8,10 HP(TE)x3Ux160mm 19" compatible

Eurocard VMEbus standard.

GENERAL SPECIFICATION

Efficiency:

Typ. 70.0-75.0%

Switching Frequency:

Typ. 100K Hz.

Circuit Topology:

Forward circuit.

Transient Response:

Typ. 3mS following a 25%

load change.

Power Density:

1.4 Watts / Cubic Inch for HDU45, HDU60.

1.9 Watts /Cubic Inch for HDU100.

Recommended Resources

Practical amplifier circuit b composed of operational amplifier LM386

Simple V-MOSFET dimmer circuit

Holley brand BD-80 refrigerator circuit

Power AC/DC converter SR03x

Contactless automatic charger

Switching integrated regulated power supply with output current of 3A

How to implement the 0-10V circuit of the inverter and motor speed control interface?: How to implement the 0-10V circuit of the inverter and motor speed control interface?How competitive is this GP9301/GP8101 solution?...; zjqmyron Motor Drive Control（Motor Control）

BLE over-the-air upgrade: TI CC2541 supports multiple hardware and software to perform air upgrades on it. There are different combinations of hardware.Currently available software includesIt is relatively easy to get the hard...; 灞波儿奔 Wireless Connectivity

Schematic diagram of serial communication interface: Initialize the GPIO corresponding to the Tx and Rx pins of the serial port...; fish001 DSP and ARM Processors

go go go, make the LED of RSL10 start blinking (there is a little easter egg at the end of the article): [i=s]This post was last edited by sunduoze on 2021-4-17 23:51[/i]Objective: Build a basic development environment to realize the Arduino interface RS10-002GEVB board onboard LED flashing Environment: ...; sunduoze onsemi and Avnet IoT Innovation Design Competition

Module Power Structure Design Guide: The main form of module power supply is DC-DC module, in addition there are AC-DC module, DC-AC (ring current) module. Unless otherwise specified, this article assumes DC-DC module....; 鬼谷清泉 Power technology

【Help】ADC acquisition: I want to use DIO0, 1, 2, 3ADC to collect four voltage values Based on the routine peripheral_server_uart, the ADC configuration is changed The value read out now is 3FFF Is the configuration wrong?...; Aaaaaoooo onsemi and Avnet IoT Innovation Design Competition

Shortcut: L0 L1 L2 L3 L4 L5 L6 L7 L8 L9 LA LB LC LD LE LF LG LH LI LJ LK LL LM LN LO LP LQ LR LS LT LU LV LW LX LY LZ M0 M1 M2 M3 M4 M5 M6 M7 M8 M9 MA MB MC MD ME MF MG MH MI MJ MK ML MM MN MO MP MQ MR MS MT MU MV MW MX MY MZ N0 N1 N2 N3 N4 N5 N6 N7 N8 NA NB NC ND NE NF NG NH NI NJ NK NL NM NN NO NP NQ NR NS NT NU NV NX NZ O0 O1 O2 O3 OA OB OC OD OE OF OG OH OI OJ OK OL OM ON OP OQ OR OS OT OV OX OY OZ P0 P1 P2 P3 P4 P5 P6 P7 P8 P9 PA PB PC PD PE PF PG PH PI PJ PK PL PM PN PO PP PQ PR PS PT PU PV PW PX PY PZ Q1 Q2 Q3 Q4 Q5 Q6 Q8 Q9 QA QB QC QE QF QG QH QK QL QM QP QR QS QT QV QW QX QY R0 R1 R2 R3 R4 R5 R6 R7 R8 R9 RA RB RC RD RE RF RG RH RI RJ RK RL RM RN RO RP RQ RR RS RT RU RV RW RX RY RZ

Popular Components