When installing the Doppler flowmeter, the sensor should be installed as close to the bottom of the channel as possible. If there are a lot of sediments, silt, water plants or stones rolling on the bo...
I tried to draw the board myself. The ceramic antenna I used was RFANT3216120A5T, and I drew it according to the data sheet. First, the balun outputted a 50Ω impedance, and then the antenna. But the r...
The TI Design demonstrates a low-power approach to wireless environmental sensing that ensures up to 10 years of battery life.This design uses the Texas Instruments (TI) SimpleLink ultra-low-power Sub...
I want to generate code using STM32Cube. Click Project, Settings, OK. Tip:Click Yes to download the firmware package, but an error occurs: Tip:It says that you can manually click the 'from local' butt...