Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
Lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The comments about instructions in this article will be slightly different from those in the previous instructions. The previous instructions are commented on to explain the specific functions of the ...
The threshold voltage of a MOS transistor is equal to the gate-to-source bias voltage required to form a channel when the backgate and source are connected together. If the gate-to-source bias voltage...
The project needs to complete the above functions, namely AD/DA, storage, transmission, control algorithm (control cycle 40us, the algorithm is slightly more complicated than PID, and requires single-...
Peter B. Green, manager of LED systems and applications at IR (International Rectifier), suggests that the approach will be very different when researching a bidirectional thyristor dimming LED d...[Details]
The high switching action of power switching devices is
the main reason for electromagnetic interference (EMI) generated by
switching power supplies
. The increase in switching frequency red...[Details]
1 Introduction
With the continuous development of wireless network technology and the gradual popularization of the network, customers' requirements for the overall voice service quality of th...[Details]
On the 13th, ZF Friedrichshafen Group officially announced that it had signed an investment cooperation agreement with the Huadu District Government of Guangzhou yesterday to build a new automotive e...[Details]
Acceleration
Sensor
It is an electronic device that can measure acceleration force. Acceleration force is the force acting on an object when it is accelerating, just like the earth's grav...[Details]
According to foreign media reports, automakers and Silicon Valley technology companies have promised to deploy driverless cars in 2019. However, so far, driverless cars have only been tested in limit...[Details]
ON Semiconductor will showcase smart solutions at the 2023 Consumer Electronics Show (CES) in Las Vegas, USA Learn about the latest innovative technologies in the industrial and automotive fields ...[Details]
Industrial palletizing robots are intelligent assembly equipment that can perform efficient and accurate material stacking and handling operations, greatly improving production efficiency and produ...[Details]
On July 13, Jiangfeng Electronics issued an announcement stating that the company issued shares to Gongchuang Lianying and paid cash to purchase 100% of the equity of Silverac Stella (Cayman) Limite...[Details]
On September 18, the real Samsung Galaxy S20 FE was exposed. Compared with the Galaxy S20, the biggest difference in the appearance of the Galaxy S20 FE is that it uses a straight screen (the Galaxy ...[Details]
Judging from the current situation, the production of the domestic version of Tesla Model Y has been fully launched. The latest drone aerial photos show that in the parking lot of the company's Shang...[Details]
The red and black test pens of multimeters are easy to use and flexible to operate, but they also have a drawback: when they need to be fixed at a certain place for measurement, or when you need to fr...[Details]
1 Introduction Power conversion efficiency test of power conditioner, efficiency test of inverter and motor, loss test of reactor, etc., all aspects of power electronics require high-precision power ...[Details]
A new Scania ultra-large electric truck is on the road in Norway. Image courtesy of Scania
Volkswagen Group-owned heavy-duty truck makers Scania and Northvolt say they have...[Details]
The 2-wire temperature sensor is a common temperature measurement device, which is widely used in industry, scientific research, medical treatment and other fields. This article will introduce in d...[Details]
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
