-
In recent years, biometric recognition technology, which uses biological features such as face, iris, retina, fingerprint, voice, and gene as identification methods, has gradually played a very goo...[Details]
-
BH1750FVI is a digital light intensity sensor integrated circuit based on IIC bus protocol. The following is its program:
#include "io430x14x.h"
typedef unsigned int uint;
typedef unsigned char uch...[Details]
-
Recently, SNE Research, an international power battery market research organization, released the global power battery shipment rankings for August 2019. The data showed that BYD, the third-ranked co...[Details]
-
O Introduction
In a non-line-of-sight mobile communication environment, it is a challenge for designers to design a communication technology that has a very high transmission rate, good service...[Details]
-
The vast majority of spraying machinery currently in use uses manual operations to spray pesticides. The sprayers decide the time, location and dosage of chemical agents based on experience. The ac...[Details]
-
First, the principle of the encoder A and B correspond to two photosensitive receiving tubes. The distance S2 between AB is smaller than S0 and S1. Therefore, when rotating clockwise, the initial v...[Details]
-
According to news on September 14, recently, GB/T20234.1-2023 "Connection Devices for Conductive Charging of Electric Vehicles Part 1: General Requirements" and GB/T20234. 3-2023 Two recommended nat...[Details]
-
On September 27, the Ministry of Industry and Information Technology released the list of national technology innovation demonstration enterprises in 2019. Among them, Internet technology companies B...[Details]
-
What AN3147 says: 1..1 How to enter Wait mode Entering Wait mode Wait mode is entered by executing the WFI or WFE assembly instruction. This stops the CPU, but other peripherals and the interrupt con...[Details]
-
As a common display device, LCD has the characteristics of low power consumption, small size, light weight, and large amount of displayed information. Especially in portable devices, it occupies an...[Details]
-
As shown in the figure above, the op amp has two input terminals a, b and an output terminal o. They are also called the inverting input terminal (inverting input terminal), the non-inverting input t...[Details]
-
As a new light source, in recent years, major companies and research institutions
have been conducting research
on LED
power supplies
and
drive
circuits
. Unlike the
electro...[Details]
-
Abstract:
This paper first briefly introduces the role of the dangerous goods handling robot and the structure of the manipulator, and focuses on the design and implementation of the manipula...[Details]
-
According to foreign media reports, NXP ® Semiconductors has launched a new wireless connection solution that complies with automotive standards - AW693. Part of NXP’s broad portfolio of automotive w...[Details]
-
Recently, senior executives of Liquid Flow Energy Storage Technology Co., Ltd. were invited to the UAE to hold a project discussion with the UAE Minister of State for Foreign Trade, and were invite...[Details]