POLYESTER FILM AND FOIL
TAPE WRAP AND EPOXY FILL CASE
668
PAGE 4 OF 4
GENERAL SPECIFICATIONS
PHYSICAL CHARACTERISTICS
CONSTRUCTION:
NON-INDUCTIVE WOUND POLYESTER FILM AND FOIL.
CASE:
TAPE WRAP CASE AND EPOXY FILL.
LEAD MATERIAL:
AXIAL SOLDER COATED OR TINNED SOLID WIRE, AWG AS SPECIFIED IN TABLES.
DIMENSIONS:
AS SPECIFIED IN TABLES.
ELECTRICAL CHARACTERISTICS
CAPACITANCE:
AS SPECIFIED IN TABLES ± REQUESTED TOLERANCE WHEN MEASURED AT OR
REFERRED TO 1000 ± 20 HZ AND 25 ± 5 °C.
TOLERANCE:
±5%, ±10%, AND ±20% AVAILABLE. OTHER TOLERANCES AVAILABLE UPON REQUEST.
DISSIPATION FACTOR:
SHALL NOT BE GREATER THAN 1.0% WHEN MEASURED AT OR REFERRED TO
1000 ± 20 HZ AND 25 ± 5 °C.
INSULATION RESISTANCE:
SHALL BE GREATER THAN 50,000 MΩ WHEN MEASURED AFTER 2
MINUTES ELECTRIFICATION AT 100VDC AND 25 ± 5 °C.
DIELECTRIC STRENGTH:
250% RATED VOLTAGE FOR 5 SECONDS THROUGH A LIMITING RESISTANCE
OF 100 OHMS/VOLT AT 25 ± 5 °C.
RATED VOLTAGE:
100VDC, 200VDC, 400VDC, 600VDC, AND 1000VDC AVAILABLE.
TEMPERATURE:
-40 °C TO +85 °C AT FULL RATED VOLTAGE OPERATIONAL TEMPERATURE, DERATE
LINEARLY 1.5%/°C ABOVE +85 °C TO +105 °C, +105 °C MAX STORAGE TEMPERATURE.
ADDITIONAL INFORMATION
ORDERING INFORMATION:
ALL ASC CAPACITORS ARE ORDERED BY "FAMILY CAP-TOL-VOLT"
DESIGNATION. (I.E. TO ORDER A 668 0.0068µF, ±5%, 400VDC CAPACITOR, REQUEST PART NUMBER
"668 .0068-5-400")
SEE ALSO:
"GENERAL INFORMATION - POLYESTER CAPACITORS" DOCUMENT FOR ADDITIONAL
PHYSICAL, ELECTRICAL, AND PERFORMANCE CHARACTERISTICS NOT MENTIONED IN THIS FILE.
WARNING:
INFORMATION ON THIS FILE IS SUBJECT TO CHANGE WITHOUT NOTICE AT ASC'S
DISCRETION.
LAST MODIFIED: 08/27/01
Phone: (308) 284-3611
Fax: (308) 284-8324
301 WEST O STREET
•
OGALLALA, NE 69153
e-mail: sales@ascapacitor.com
web: www.ascapacitor.com