The software used is Allegro.
When laying out the layout, the grid is set to be larger, usually more than 10, as a large grid facilitates device alignment.
When wiring, the grid points are generally s...
The following figure shows a buck-boost circuit generated using TI WEBENCH. The main control IC is LM5118.The parameters are as followsInput voltage range: DC22.0V-DC45V;Output voltage: DC24.0V;Contin...
Thanks to EEWorld for providing the test development board. Let's unbox the GD32L233C start. I won't go into details about the specific parameters, as many netizens have shared them in detail. I'll up...
I have been engaged in embedded software development for more than 10 years. I like technical development, and I have not made any efforts to develop my career in the direction of management. I am als...
Dear experts, it is said that when the positive and negative inputs of an op amp are equal, the output is 0. Does this 0 refer to the middle point of the positive and negative power supplies, or the a...
[i=s]This post was last edited by 不足论 on 2020-1-19 16:56[/i]Continued from the previous article:
https://en.eeworld.com/bbs/thread-1066428-1-1.html
I have written a year-end summary on EEWorld in rece...